UM1535 datasheet(13/39 Pages) STMICROELECTRONICS

13 / 39 page

UM1535

Working with pre-flashed software

Doc ID 023036 Rev 2

13/39

Plug the card into the board slot and wait for the Linux kernel to autodetect it (you can

see active kernel messages on the terminal)

Mount the card's file system:

# mount /dev/mmcblk0p1 /mnt

Now the card's file system can be accessed under the /mnt directory.

Transfer files as usual (for example, cp command)

When finished, unmount the card:

# umount /mnt

Now you can physically remove the card.

2.6

Using a SATA hard disk

Some evaluation boards (currently EVALSP1340CPU) support SATA.

An example of the operation sequence for a SATA hard disk is the following:

Mount the SATA file system:

# mount /dev/sda1 /mnt

Now the SATA file system can be accessed under /mnt directory.

Transfer files as usual (for example, cp command).

When finished, unmount the SATA:

# umount /mnt

Now you can physically unplug the SATA.

2.7

Entering the U-Boot resident monitor

The U-Boot resident monitor offers an interactive command-line interface that can be used

through the serial console. U-Boot is executed before starting the Linux OS. In order to

interrupt the normal boot process and enter U-Boot operation mode, press a key from the

virtual terminal on the Windows or Linux PC during the initial period (after hardware reset)

when the following message is displayed:

Hit SPACE to stop autoboot: _

To obtain a full list of U-Boot commands available on SPEAr board, enter the "help"

command or simply type the "?" character. When "help" is followed by a command name, a

description of that specific command is displayed.

The following subsections describe basic usage scenarios.

Please note that command results are only shown as examples and can look slightly

different depending on the evaluation board and software version you use.

Detailed documentation about the described commands, as well as additional ones, may be

found on the main U-Boot Web site: http://www.denx.de/wiki/U-Boot.

Note:

Not all the commands mentioned in denx are implemented in U-Boot.

2.7.1

Information commands

To report the U-Boot version currently available on the evaluation board Flash memory,

execute the "version" command:

UM1535 数据表(PDF) 13 Page - STMicroelectronics

UM1535 数据表(HTML) 13 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39

数据表下载