7

LT1370

Unique error amplifier circuitry allows the LT1370 to

directly regulate negative output voltages. The negative

feedback amplifier’s 100k source resistor is brought out

for negative output voltage sensing. The NFB pin regulates

at – 2.48V while the amplifier output internally drives the

FB pin to 1.245V. This architecture, which uses the same

main error amplifier, prevents duplicating functions and

maintains ease of use. Consult LTC Marketing for units

that can regulate down to – 1.25V.

The error signal developed at the amplifier output is

functions. It is used for frequency compensation, current

limit adjustment and soft starting. During normal regula-

tor operation this pin sits at a voltage between 1V (low

output current) and 1.9V (high output current). The error

be externally clamped for lowering current limit. Like-

wise, a capacitor coupled external clamp will provide soft

below the control pin threshold, placing the LT1370 in an

idle mode.

Positive Output Voltage Setting

FB pin to ground. Output voltage is set by connecting the

FB pin to an output resistor divider (Figure 1). The FB pin

bias current represents a small error and can usually be

ignored for values of R2 up to 7k. The suggested value for

R2 is 6.19k. The NFB pin is normally left open for positive

output applications. Positive fixed voltage versions are

available (consult LTC Marketing).

Negative Output Voltage Setting

NFB pin to ground. Output voltage is set by connecting the

NFB pin to an output resistor divider (Figure 2). The

–30

voltage errors and should not be ignored. This has been

accounted for in the formula in Figure 2. The suggested

value for R2 is 2.49k. The FB pin is normally left open for

negative output applications.

Dual Polarity Output Voltage Sensing

Certain applications benefit from sensing both positive

and negative output voltages. One example is the “Dual

Output Flyback Converter with Overvoltage Protection”

circuit shown in the Typical Applications section. Each

output voltage resistor divider is individually set as

described above. When both the FB and NFB pins are used,

R1

R2

FB

PIN

R2

R1 = R2

– 1

()

1.245

LT1370 • F01

APPLICATIO S I FOR ATIO

Figure 1. Positive Output Resistor Divider

the LT1370 acts to prevent either output from going

beyond its set output voltage. For example, in this applica-

tion if the positive output were more heavily loaded than

the negative, the negative output would be greater and

would regulate at the desired set-point voltage. The posi-

tive output would sag slightly below its set-point voltage.

This technique prevents either output from going unregu-

lated high at no load.

Figure 2. Negative Output Resistor Divider

R1

1 +

R2

LT1370 • F02

NFB

PIN

R2

R1 =

+ 30 • 10

–6

( ) (

)

2.48

R2