5

LTC1405

PI FU CTIO S

mon mode for single supply operation. Bypass to GND

with a 1

µF to 10µF ceramic.

SENSE (Pin 4): Reference Programming Pin. Ground

10

µF ceramic.

GND (Pin 6): DAC Reference Ground.

to 10

µF ceramic.

GND (Pin 8): Analog Power Ground.

D11 to D0 (Pins 9 to 20): Data Outputs. The output format

is two’s complement.

OGND (Pin 21): Output Logic Ground. Tie to GND.

Connect to Pin 23 for 5V logic. If not shorted to Pin 23,

bypass to GND with a 1

µF ceramic.

ceramic.

GND (Pin 24): Analog Power Ground.

not shorted to GND, bypass to GND with a 1

µF ceramic.

CLK (Pin 26): Conversion Start Signal. This active high

signal starts a conversion on its rising edge.

OF (Pin 27): Overflow Output. This signal is high when the

digital output is 011111111111 or 100000000000.

GAIN (Pin 28): Gain Select for Input PGA. 5V selects an

input gain of 1, 0V selects a gain of 2.

Note 6: Dynamic specifications are guaranteed for dual supply operation

dynamic specifications, refer to the Typical Performance Characteristics.

Note 7: Integral nonlinearity is defined as the deviation of a code from a

straight line passing through the actual endpoints of the transfer curve.

The deviation is measured from the center of the quantization band.

Note 8: Bipolar offset is the offset voltage measured from –0.5LSB

when the output code flickers between 0000 0000 0000 and

1111 1111 1111.

Note 9: Guaranteed by design, not subject to test.

Note 10: Recommended operating conditions.

ELECTRICAL CHARACTERISTICS