LTC699CS8 datasheet(3/4 Pages) LINER

3 / 4 page

LTC699

but not serviced prior to the time-out period, the reset

pulse generator also forces RESET to active low for a mini-

mum of 140ms for every time-out period (see Figure 2).

WDI: Watchdog Input, WDI, is a three level input. Driving

WDI either high or low for longer than the watchdog time-

out period forces RESET low. Floating WDI disables the

Watchdog Timer. The timer resets itself with each transition

of the Watchdog Input (see Figure 2).

VCC: +5V supply input. The VCC pin should be bypassed

with a 0.1

µF capacitor.

GND: Ground pin.

RESET: Open drain output for

µP reset control. When VCC

falls below the reset voltage threshold (4.65V typically),

RESET goes active low. After VCC returns to 5V, the reset

pulse generator forces RESET to remain active low for a

minimum of 140ms . When the watchdog timer is enabled

PI FU CTIO S

Information furnished by Linear Technology Corporation is believed to be accurate and reliable.

However, no responsibility is assumed for its use. Linear Technology Corporation makes no represen-

tation that the interconnection of circuits as described herein will not infringe on existing patent rights.

SUPPLY VOLTAGE (V)

LTC699 G01

TA = 25°C

EXTERNAL PULLUP = 10

µA

TEMPERATURE (

°C)

–50

216

224

232

LTC699 G02

208

200

–25

100

125

192

184

VCC = 5V

Reset Voltage Threshold vs

Temperature

HARA TERISTICS

TYPICALPERFOR

down, the RESET signal remains active low even with VCC

as low as 1V. This capability helps hold the microproces-

sor in stable shutdown condition. Figure 1 shows the

timing diagram of the RESET signal.

The precision voltage comparator, C1, typically has 40mV

of hysteresis which ensures that glitches at VCC pin do not

activate the RESET output. Response time is typically

µs.Tohelppreventmistriggeringduetotransientloads,

VCC pin should be bypassed with a 0.1µF capacitor with the

leads trimmed as short as possible.

Microprocessor Reset

The LTC699 uses a bandgap voltage reference and a

precision voltage comparator C1 to monitor the 5V supply

input VCC (see BLOCK DIAGRAM). When VCC falls below

the reset voltage threshold, the RESET output is forced to

active low state. The reset voltage threshold accounts for

a 5% variation on VCC, so the RESET output becomes

active low when VCC falls below 4.65V typical. On power-

up, the RESET signal is held active low for a minimum of

140ms after reset voltage threshold is reached to allow the

power supply and microprocessor to stabilize. On power-

APPLICATI

I FOR ATIO

RESET Output Voltage vs

Supply Voltage

Reset Active Time vs

Temperature

TEMPERATURE (

°C)

–50

4.64

4.65

4.66

LTC699 G03

4.63

4.62

–25

100

125

4.61

4.60

LTC699CS8 数据表(PDF) 3 Page - Linear Technology

LTC699CS8 数据表(HTML) 3 Page - Linear Technology

Html Pages

1 2 3 4

数据表下载