HTX datasheet(9/36 Pages) RMT

9 / 36 page

OPERATING MANUAL. HTX SERIES

Page 9 of 36

3.2 Preparations for working

You need to procure the following for working with the Sensors:

Mounting substance (i.e. tape, paste, or glue) to mount the Sensor in

your setup.

Read-out device (i.e. RMT DX8140 Datalogger, millivoltmeter,

ohmmeter), or third party read-out device. Note that the read-out

device must have passive input for Sensor and active input for

working with Pt1000 thermistor.

Device for Sensor self-calibration procedure. If RMT DX8140

Datalogger is procured, the procedure is available. Otherwise any

model of RMT Z-meters is suitable for that.

3.3 Sensor testing

Before mounting the Sensor must be tested as described in Chapter 6.

3.4 Sensor calibration

If necessary, or required for an application the Sensor can be calibrated by

the self-calibration procedure described in Chapter 10.

3.5 Mounting of the Sensor

Ensure that the mounting surface is flat, dry, and free of dust and grease.

Clean the Sensor surface with ethanol or isopropanol. Do not use acids or

alkali for cleaning the Sensor. Mount the Sensor using a mounting

substance. A detailed description of the Sensor mounting is given in

Chapter 6.

The common mounting scheme is advised in Fig. 4.1

HTX 数据表(PDF) 9 Page - RMT Ltd.