How to Read a Conversion

A standard interrupt signal, INT, is provided to allow the

device to flag the µP when the conversion has ended

and a valid result is available. INT goes low when the

conversion is complete and the output data is ready

(Figures 5 and 6). It returns high on the first read cycle

or if a new control byte is written.

Clock Modes

The MAX199 operates with either an internal or an

external clock. Control bits (D6, D7) select either inter-

nal or external clock mode. Once the desired clock

mode is selected, changing these bits to program

power-down will not affect the clock mode. In each

mode, internal or external acquisition can be used. At

power-up, the MAX199 defaults to external clock mode.

Internal Clock Mode

Select internal clock mode to free the µP from the

burden of running the SAR conversion clock. To select

this mode, write the control byte with D7 = 0 and D6 = 1.

A 100pF capacitor between the CLK pin and ground

sets this frequency to 1.56MHz nominal. Figure 7

shows a linear relationship between the internal clock

period and the value of the external capacitor used.

Multi-Range (±4V, ±2V, +4V, +2V),

+5V Supply, 12-Bit DAS with 8+4 Bus Interface

______________________________________________________________________________________

11

ACQMOD = "1"

CS

WR

D7–D0

INT

RD

HBEN

DOUT

ACQMOD = "0"

HIGH / LOW

BYTE VALID

HIGH-Z

HIGH-Z

HIGH / LOW

BYTE VALID

CONTROL

BYTE

CONTROL

BYTE

Figure 6. Conversion Timing Using External Acquisition Mode

2000

0

0

50

250

350

500

CLOCK PIN CAPACITANCE (pF)

100

150 200

300

1500

1000

Figure 7. Internal Clock Period vs. Clock Pin Capacitance