IR1167AS datasheet(12/25 Pages) IRF

12 / 25 page

IR1167(A,B)S

www.irf.com

Nov 6, 2013

General Description

The IR1167 Smart Rectifier IC can emulate the operation of diode rectifier by properly driving a Synchronous Rectifier (SR)

MOSFET. The direction of the rectified current is sensed by the input comparator using the power MOSFET RDSon as a shunt

resistance and the GATE pin of the MOSFET is driven accordingly. Internal blanking logic is used to prevent spurious

transitions and guarantee operation in continuous (CCM), discountinuous (DCM) and critical (CrCM) conduction mode.

Figure 1: Input comparator thresholds

Flyback Application

The modes of operation for a Flyback circuit differ mainly for the turn-off phase of the SR switch, while the turn-on phase of the

secondary switch (which corresponds to the turn off of the primary side switch) is identical.

Turn-on phase

When the conduction phase of the SR FET is initiated, current will start flowing through its body diode, generating a negative

VDS voltage across it. The body diode has generally a much higher voltage drop than the one caused by the MOSFET on

resistance and therefore will trigger the turn-on threshold VTH2.

At that point the IR1167 will drive the gate of MOSFET on which will in turn cause the conduction voltage VDS to drop down.

This drop is usually accompanied by some amount of ringing, that can trigger the input comparator to turn off; hence, a

Minimum On Time (MOT) blanking period is used that will maintain the power MOSFET on for a minimum amount of time.

The programmed MOT will limit also the minimum duty cycle of the SR MOSFET and, as a consequence, the max duty cycle

of the primary side switch.

DCM/CrCM Turn-off phase

Once the SR MOSFET has been turned on, it will remain on until the rectified current will decay to the level where VDS will

cross the turn-off threshold VTH1. This will happen differently depending on the mode of operation.

In DCM the current will cross the threshold with a relatively low dI/dt. Once the threshold is crossed, the current will start

flowing again through the body diode, causing the VDS voltage to jump negative. Depending on the amount of residual current,

VDS may trigger once again the turn on threshold: for this reason VTH2 is blanked for a certain amount of time (TBLANK) after

VTH1 has been triggered.

The blanking time is internally set. As soon as VDS crosses the positive threshold VTH3 also the blanking time is terminated and

the IC is ready for next conduction cycle.

VGate

VTH1

VTH2

VTH3

VDS

IR1167AS 数据表(PDF) 12 Page - International Rectifier

IR1167AS 数据表(HTML) 12 Page - International Rectifier

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25

数据表下载