LP2950, LP2951

www.ti.com

SLVS582I – APRIL 2006 – REVISED NOVEMBER 2014

6.5 Electrical Characteristics

PARAMETER

TEST CONDITIONS

MIN

TYP

MAX

UNIT

3-V VERSION (LP295x-30)

25°C

2.970

3

3.030

Output voltage

V

–40°C to 125°C

2.940

3

3.060

3.3-V VERSION (LP295x-33)

25°C

3.267

3.3

3.333

Output voltage

V

–40°C to 125°C

3.234

3.3

3.366

5-V VERSION (LP295x-50)

25°C

4.950

5

5.050

Output voltage

V

–40°C to 125°C

4.900

5

5.100

ALL VOLTAGE OPTIONS

Output voltage temperature

–40°C to 125°C

20

100 ppm/°C

25°C

0.03

0.2

%/V

–40°C to 125°C

0.4

25°C

0.04%

0.2%

—

–40°C to 125°C

0.3%

25°C

50

80

–40°C to 125°C

150

(3)

mV

25°C

380

450

–40°C to 125°C

600

25°C

75

120

μA

–40°C to 125°C

140

GND current

25°C

8

12

mA

–40°C to 125°C

14

25°C

110

170

Dropout ground current

μA

–40°C to 125°C

200

25°C

160

200

Current limit

mA

–40°C to 125°C

220

25°C

0.05

0.2

%/W

430

160

Output noise (RMS),

25°C

μV

10 Hz to 100 kHz

100

pins 1 and 7

(1)

Output or reference voltage temperature coefficient is defined as the worst-case voltage change divided by the total temperature range.

(2)

Regulation is measured at constant junction temperature, using pulse testing with a low duty cycle. Changes in output voltage due to

heating effects are covered under the specification for thermal regulation.

(3)

Dropout voltage is defined as the input-to-output differential at which the output voltage drops 100 mV, below the value measured at 1-V

differential. The minimum input supply voltage of 2 V (2.3 V over temperature) must be observed.

(4)

Thermal regulation is defined as the change in output voltage at a time (T) after a change in power dissipation is applied, excluding load

Copyright © 2006–2014, Texas Instruments Incorporated

Submit Documentation Feedback

5

Product Folder Links: LP2950 LP2951