MAX953CSLASHD datasheet(4/12 Pages) MAXIM

4 / 12 page

µA

Ultra-Low-Power, Single-Supply

Op Amp + Comparator + Reference

_______________________________________________________________________________________

RL = 100kΩ to VSS

TA = +25°C, VDD - VSS = 5V

TA = +25°C

MAX95_M

TA = +25°C

TA = +25°C, VDD - VSS = 5V

MAX95_M

MAX95_E

CONDITIONS

VSS + 50mV

VOL

Output Low Voltage

VDD - 500mV

VOH

Output High Voltage

200

570

300

820

UNITS

MIN

TYP

MAX

SYMBOL

PARAMETER

ELECTRICAL CHARACTERISTICS (continued)

(VDD = 2.8V to 7V for MAX951/MAX952, VDD = 2.4V to 7V for MAX953/MAX954, VSS = 0V, VCM COMP = 0V for the MAX953/MAX954,

VCM OPAMP = 0V, AMPOUT = (VDD + VSS) / 2, COMPOUT = low, TA = TMIN to TMAX, typical values are at TA = +25°C, unless

otherwise noted.)

Note 1: Supply current is tested with COMPIN+ = (REF - 100mV) for MAX951/MAX952, and COMPIN+ = 0V for MAX953/MAX954.

Note 2: Input Offset Voltage is defined as the center of the input-referred hysteresis. VCM COMP = REF for MAX951/MAX952, and

VCM COMP = 0V for MAX953/MAX954.

Note 3: Trip Point is defined as the differential input voltage required to make the comparator output change. The difference

between upper and lower trip points is equal to the width of the input-referred hysteresis. VCM COMP = REF for

MAX951/MAX952, and VCM COMP = 0V for MAX953/MAX954.

Note 4: For MAX951/MAX952, input leakage current is measured for COMPIN- at the reference voltage. For MAX953/MAX954, input

leakage current is measured for both COMPIN+ and COMPIN- at VSS.

Note 5: Reference voltage is measured with respect to VSS. Contact factory for availability of a 3% accurate reference voltage in the

µMAX package.

ISRC

Output Source Current

µA

ISNK

Output Sink Current

µA

MAX953C/D 数据表(PDF) 4 Page - Maxim Integrated Products

MAX953C/D 数据表(HTML) 4 Page - Maxim Integrated Products

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12

数据表下载