©2015 Glenair, Inc.

REV: 3

US Cage Code 06324

Printed in USA

GLENAIR, INC.

∙ 1211 AIR WAY ∙ GLENDALE, CA 91201-2497

∙ TEL: 818-247-6000

∙ FAX: 818-500-9912

www.glenair.com

PAGE 11 of 15

E-mail: sales@glenair.com

050-320 Product Brief

PCB Mount Dual Receiver for Single Mode Fiber

100 Mbps – 4.25 Gbps, 3.3V

Electrostatic Discharge (ESD)

The Dual-Receiver is compatible with ESD levels found in typical manufacturing and operating environments as

described JEDEC EIA JESD22-A114, Class 1C (<2000Volts) HBM. Glenair recommends that devices are handled with

ESD precautions to limit exposure to below 500V HBM.

There are two design cases in which immunity to ESD damage is important. The first case is during handling of the Dual-

Receiver prior to insertion to the host board. To protect the Dual-Receiver, it’s important to use standard industry ESD

handling precautions. These precautions include using grounded wrist straps, work benches, and floor mats in ESD

controlled areas. The ESD sensitivity of the Glenair PCB mount Dual-Receiver is compatible with typical industry

production environments.

The second case to consider is static discharges to the exterior of the host equipment after installation, in which case the

Dual-Receiver may be subject to system-level ESD requirements.

Application Support

To assist in the Dual-Receiver design and evaluation process, Glenair offers the following aids:

•

Evaluation board & Product Manual, part number 050-330, which facilitates in the testing of the PCB mount Dual-

Receiver.

•

3D Step file to support modeling of mechanical fit and routing

•

PADS schematic and PCB layout library files that can be exported into customer’s PCB software design program

•

Applications Aid Example of PCB layout including details of high speed transmission designs

Customer Manufacturing Processes

This module is mounted with screws and interfaces with a high-speed low cost surface mount electrical connector residing

on the host PC board. The PCB mount Dual-Receiver is not designed for aqueous wash, IR reflow, or wave soldering

processes and should be mounted on the host board after host PC board has been through its assembly process.