53262 datasheet(2/4 Pages) MICROPAC

2 / 4 page

Micropac Industries cannot assume any responsibility for any circuits shown or represent that they are free from patent infringement.

Micropac reserves the right to make changes at any time in order to improve design and to supply the best product possible.

MICROPAC INDUSTRIES, INC. MICROCIRCUITS DIVISION • 905 E. Walnut St., Garland, TX 75040 • (972) 272-3571 • Fax (972) 494-2281

www.micropac.com

E-MAIL: hybridsales@micropac.com

05/16/2002

Pg. 2 of 4

53262

Short Circuit Protected Solid State Relay

__________________________________________________________________________________________

ELECTRICAL SPECIFICATIONS

TC = -40°C to +85°C, unless otherwise specified.

Parameter

Symbol

Min.

Typ.*

Max.

Unit

Test Conditions

Notes

INPUT CHARACTERISTICS

Input Forward Voltage

2.0

2.7

3.8

VDC

IF = 8 mA

Input Reverse Breakdown Voltage



VDC

IR = 10 µA

OUTPUT CHARACTERISTICS

Output On-Resistance

R (ON)



0.8

1.2

Ω

IF = 8 mA, IO = 0.5 A

Pulse width = 10 ms

Duty cycle

≤ 10%

Output Leakage Current

IO (OFF)



250

µA

VF = 0.6 VDC

VO = 400 VDC

Turn-On Time

tON



Turn-Off time

tOFF



Rise Time



Fall Time



IF = 8 mA

IO = 0.5 A

Pulse width = 10 ms

Duty cycle

≤ 10%

3 &

Figure 2

Over-current Limit

ICL

1.1



4.5

Over-current Trip Time

tCL



VO = 54 VDC

RL = 12 Ω

Peak Short Circuit Current

ISC(PK)



Short Circuit Shut Down Time

tSC



100

µs

Short-while-on

@ TC = 25°C

5 & 7

COMMON CHARACTERISTICS

Input-Output Leakage Current

II-O



µA

≤ 45%, t = 5 s

VI-O = 1000 VDC

TC = 25°C

1 & 2

Thermal Resistance (junction-case)

θJC



18.5



°C/W

* Typical values are at TC = 25°C

Notes:

1. Input pins shorted together and output pins shorted together.

2. Input -output potential applied momentarily, not a steady state operating condition.

3. Rise time is measured from 10% to 90% of load current (90% to 10% of VO). Fall time is measured from 90% to

10% of load current (10% to 90% of VO). Guaranteed but not tested.

4. The minimum over-current limit occurs at Tc of 85°C. The maximum over-current limit occurs at Tc of -40°C.

5. Use 0.25 ohm sense resistor for monitoring the peak short circuit current.

6. The user should apply the appropriate transient suppression technique to the output terminals of the relay when

the loads are inductive enough to generate voltage spikes.

7. Guaranteed but not tested.

53262 数据表(PDF) 2 Page - Micropac Industries

53262 数据表(HTML) 2 Page - Micropac Industries

Html Pages

1 2 3 4

数据表下载