16

ELECTRICAL CHARACTERISTICS

The Electrical Characteristics are guaranteed over the following range of operating conditions, unless otherwise stated:

40°C to

85°C,

55°C to

125°C

Static Characteristics

Output high voltage

Output low voltage

Input high voltage

Input low voltage

Input leakage current

Input capacitance

Output leakage current

Output short circuit current

Current at full speed

8mA

5·5V

Conditions

Characteristic

Min.

Typ. Max.

10

-

0·4

-

0·8

10

50

300

Max.

2·4

-

2·0

-

10

50

10

V

V

V

V

µA

pF

µA

mA

mA

Value

Symbol

NOTE: Signal pins PC0, X15, MASTER, SINGLE and OVR have pullup resistors in the range 15k

Ω to 200kΩ. BYPASS, PROG and DS have no internal pullup

resistors. When the device is used in EPROM mode, external pullup resistors should be connected to the PROG and DS pins.

Units

ABSOLUTE MAXIMUM RATINGS (NOTE 1)

Static discharge voltage (HBM)

Commercial grade

Industrial grade

Military grade

Package power dissipation

Thermal resistance, junction-to-case,

θ

JC

0·5V to

7·0V

0·5V

0·5V

18mA

500V

65°C to 150°C

95°C

110°C

150°C

2000mW

5°C/W

PDSP16488A MA ACBR and PDSP16488A MA GCPR

(MIL-STD-883 CLASS B PARTS)

Polyimide is used as an inter-layer dielectric and as

glassification. Polymeric material is also used for die attach

which, according to the requirements in paragraph 1.2.1, pre-

cludes categorising these devices as fully compliant. In every

other respect, these devices are manufactured and screened in

full accordance with MIL-STD-883 (latest revision).

The PDSP16488A MA ACBR (PGA packge) is subject to the

constant acceleration test, Method 2001, Test Condition A (5kg).

Life test/burn-in connections are given in Tables 12 and 13 on

the following page.

Change Notification

The change notification requirements of MIL-PRF-38535

will be implemented on MIL-STD-883 grade devices. Known

customers will be notified of any changes since the last buy

when ordering further parts if significant changes have been

made.

Rev.

Date

A

MAR 1993

B

JUL 1996

C

NOV 1997

D

NOTES

1. Exceeding these ratings may cause permanent damage.

Functional operation under these conditions is not implied.

2. Maximum dissipation should not be exceeded for more

than1 second, only one output to be tested at any one time.

3. Exposure to absolute maximum ratings for extended

periods may affect device reliablity.

4. Current is defined as negative into the device.