Z86L7208FSC datasheet(44/71 Pages) ZILOG

44 / 71 page

Z86C72/C92/L72/L92

IR Microcontroller

Zilog

6-44

P R E L I M I N A R Y

DS97LVO0900

FUNCTIONAL DESCRIPTION (Continued)

T16 Transmit Mode

In Normal or Ping-Pong Mode, the output of T16 when not

enabled is dependent on CTR1, D0. If it is a 0, T16_OUT

is a 1; if it is a 1, T16_OUT is 0. The user can force the out-

put of T16 to either a 0 or 1 whether it is enabled or not by

programming CTR1 D3, D2 to a 10 or 11.

When T16 is enabled, TC16H * 256 + TC16L is loaded,

and T16_OUT is switched to its initial value (CTR1 D0).

When T16 counts down to 0, T16_OUT is toggled (in Nor-

mal or Ping-Pong Mode), an interrupt is generated if en-

abled (CTR2 D1), and a status bit (CTR2 D5) is set. Note

that global interrupts will override this function as de-

scribed in the interrupts section. If T16 is in Single-Pass

Mode, it is stopped at this point. If it is in Modulo-N Mode,

it is loaded with TC16H * 256 + TC16L and the counting

continues.

The user can modify the values in TC16H and TC16L at

any time. The new values take effect when they are load-

ed. Care must be taken not to load these registers at the

time the values are to be loaded into the counter/timer, to

ensure known operation. An initial count of 1 is not al-

lowed. An initial count of 0 will cause T16 to count from 0

to %FF FF to %FFFE. Transition from 0 to %FFFF is not a

time-out condition.

Figure 29. 16-bit Counter/Timer Circuits

Z8 Data Bus

Pos Edge

Neg Edge

CTR2 D2

IRQ3

CTR2 D1

T16_OUT

TC16L

TC16H

Clock

Select

SCLK

CTR2 D4, D3

Clock

16-Bit

Counter

T16

HI16

LO16

Z8 Data Bus

Z86L7208FSC 数据表(PDF) 44 Page - Zilog, Inc.

Z86L7208FSC 数据表(HTML) 44 Page - Zilog, Inc.

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71

数据表下载