LMV331M5SLASHNOPB datasheet(11/38 Pages) TI1

11 / 38 page

LMV331-N, LMV339-N, LMV393-N

www.ti.com

SNOS018H – AUGUST 1999 – REVISED DECEMBER 2014

Application Information (continued)

The total hysteresis provided by the network is defined as:

ΔVa = Va1 - Va2

(3)

To assure that the comparator will always switch fully to VCC and not be pulled down by the load the resistors

values should be chosen as follow:

RPULL-UP << RLOAD

(4)

and R1 > RPULL-UP.

(5)

Figure 11. Inverting Comparator With Hysteresis

8.1.2.1.1

Non-inverting Comparator With Hysteresis

Non-inverting comparator with hysteresis requires a two resistor network, and a voltage reference (Vref) at the

inverting input. When Vin is low, the output is also low. For the output to switch from low to high, Vin must rise up

to Vin1 where Vin1 is calculated by:

(6)

When Vin is high, the output is also high. To make the comparator switch back to its low state, Vin must equal Vref

before VA will again equal Vref. Vin can be calculated by:

(7)

The hysteresis of this circuit is the difference between Vin1 and Vin2.

Submit Documentation Feedback

Product Folder Links: LMV331-N LMV339-N LMV393-N

LMV331M5/NOPB 数据表(PDF) 11 Page - Texas Instruments