V23832-T2131-M101

V23832-R121-M101

Description

Data Sheet

9

2003-11-19

Receiver V23832-R121-M101

The PAROLI receiver module converts parallel optical input signals into parallel electrical

output signals. The optical signals received are converted into voltage signals by PIN

diodes, trans impedance amplifiers, and gain amplifiers. There are two different modules

available, one for LVDS and one for CML output. This description only refers to a module

with LVDS output. A module description for Infineon’s adjustable CML output can be

provided separately.

The data rate is up to 1600 Mbit/s for each channel. The receiver module’s min. data rate

of 500 Mbit/s is specified for the CID

with a lower disparity.

Additional Signal Detect outputs (SD1 active high / –SD12 active low) show whether an

optical AC input signal is present at data input 1 and/or 12. The signal detect circuit can

be disabled with a logic low at ENSD. The disabled signal detect circuit will permanently

generate an active level at Signal Detect outputs, even if there is insufficient signal input.

This could be used for test purposes.

A logic low at LVDS Output Enable (OEN) sets all data outputs to logic low. SD outputs

will not be effected.

All non data signals have LVCMOS levels. Transmission delay of the PAROLI system is

at a maximum 1 ns for the transmitter, 1 ns for the receiver and approximately 5 ns per

meter for the fiber optic cable.

Figure 5

Receiver Block Diagram

1)

Consecutive Identical Digit (CID) immunity test pattern for STM-N signals,

ITU-T recommendation G.957 sec. II.

Pin

Diode

Array

LVDS

Output

Stage

12

12

Data Out

Data

Optical

Input

Electrical

Output

12

Gain

Amplifier

Signal

Detect

Circuit

12

Amplifier

Output Enable (OEN)

ENSD

SD1

−SD12

File: 3333