R5973D datasheet(31/39 Pages) STMICROELECTRONICS

31 / 39 page

DocID026876 Rev 1

31/39

R5973D

Application information

Figure 19. Negative buck-boost regulator

8.7

Synchronization example

See Section 5.3: Oscillator and synchronization on page 10 for details.

Figure 20. Synchronization example

8.8

Compensation network with MLCC at the output

MLCCs (multiple layer ceramic capacitor) with values in the range of 10 µF - 22 µF and

rated voltages in the range of 10 V - 25 V are available today at relatively low cost from

many manufacturers.

These capacitors have very low ESR values (a few m

) and thus are occasionally used for

the output filter in order to reduce the voltage ripple and the overall size of the application.

However, a very low ESR value affects the compensation of the loop (see Section 7 on page

16) and in order to keep the system stable, a more complicated compensation network may

be required. However, due to the architecture of the internal error amplifier the bandwidth

with this compensation is limited.

That is why output capacitors with a not negligible ESR are suggested. The selection of the

output capacitor has to guarantee that the zero introduced by this component is inside the

designed system bandwidth and close to the frequency of the double pole introduced by the

R5973D 数据表(PDF) 31 Page - STMicroelectronics