SAFC161S datasheet(41/75 Pages) INFINEON

41 / 75 page

C161S

Electrical Parameters

Data Sheet

V1.0, 2003-11

Port 6 active current

P6L

-500

–

µA

OUT = VOL1max

PORT0 configuration current

P0H

–

-10

µA

IN = VIHmin

P0L

-100

–

µA

IN = VILmax

XTAL1 input current

CC –

±20

µA0 V < V

IN < VDD

Pin capacitance

(digital inputs/outputs)

CC –

f = 1 MHz,

A = 25 °C

1) Keeping signal levels within the levels specified in this table, ensures operation without overload conditions.

For signal levels outside these specifications also refer to the specification of the overload current

OV.

2) Valid in bidirectional reset mode only.

3) This specification is not valid for outputs which are switched to open drain mode. In this case the respective

output will float and the voltage results from the external circuitry.

4) These parameters describe the RSTIN pull-up, which equals a resistance of ca. 50 to 250 k

Ω.

5) The maximum current may be drawn while the respective signal line remains inactive.

6) The minimum current must be drawn in order to drive the respective signal line active.

7) This specification is only valid during Reset and Adapt Mode.

8) Not subject to production test, verified by design/characterization.

Table 9

DC Characteristics (Standard Supply Voltage Range) (cont’d)

(Operating Conditions apply)

Parameter

Symbol

Limit Values

Unit Test Condition

Min.

Max.

SAFC161S 数据表(PDF) 41 Page - Infineon Technologies AG

SAFC161S 数据表(HTML) 41 Page - Infineon Technologies AG

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75

数据表下载