|||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||

||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||

2015-07-0022

PT0479-3

08/05/15

4

PI3CH200

2-Bit Bus Switch, Enable Low1.8V/2.5V/

3.3V, High-Bandwidth, Hot Plug

Note:

1. See test circuit and waveforms.

2. This parameter is guaranteed but not tested on Propagation Delays.

3. The switch contributes no propagation delay other than the RC delay of the On-Resistance of the switch and the load capacitance. The

time constant for the switch alone is of the order of 0.30ns for 10pF load. Since this time constant is much smaller than the rise/fall

times of typical driving signals, it adds very little propagation delay to the system. Propagation delay of the switch when used in a

system is determined by the driving circuit on the driving side of the switch and its interaction with the load on the driven side.

Over 2.5V Operating Range

Symbol

Description

Test Conditions

(1)

Min

Typ

Max

Unit

Propagation Delay

See test Diagram

-

-

0.3

ns

Enable Time ENx to Ax or Bx

See test Diagram

1.5

-

15.0

Disable Time ENx to Ax or Bx

See test Diagram

1.5

-

12.0

Note:

1. See test circuit and waveforms.

2. This parameter is guaranteed but not tested on Propagation Delays.

3. The switch contributes no propagation delay other than the RC delay of the On-Resistance of the switch and the load capacitance. The

time constant for the switch alone is of the order of 0.30ns for 10pF load. Since this time constant is much smaller than the rise/fall

times of typical driving signals, it adds very little propagation delay to the system. Propagation delay of the switch when used in a

system is determined by the driving circuit on the driving side of the switch and its interaction with the load on the driven side.

Over 1.8V Operating Range

Symbol

Description

Test Conditions

(1)

Min

Typ

Max

Unit

Propagation Delay

See test Diagram

-

-

0.3

ns

Enable Time ENx to Ax or Bx

See test Diagram

1.5

-

25.0

Disable Time ENx to Ax or Bx

See test Diagram

1.5

-

12.0

Note:

1. See test circuit and waveforms.

2. This parameter is guaranteed but not tested on Propagation Delays.

3. The switch contributes no propagation delay other than the RC delay of the On-Resistance of the switch and the load capacitance. The

time constant for the switch alone is of the order of 0.30ns for 10pF load. Since this time constant is much smaller than the rise/fall

times of typical driving signals, it adds very little propagation delay to the system. Propagation delay of the switch when used in a

system is determined by the driving circuit on the driving side of the switch and its interaction with the load on the driven side.

Test Circuit for Electrical Characteristics

Notes:

4. The outputs are measured one at a time with one transition per measurement.

D.U.T

Pulse

Generator

RT

10pF

200Ω

200Ω

6.0V