OUTPUT AMPLITUDE ADJUSTMENT

The high and low output levels of the CLC006 are set by a

circuit shown simplified in

Figure 8. Output high and low lev-

els may be set independently with external resistor networks

connected between R

power supplies. The resistor networks affect the high and

low output levels by changing the internally generated bias

voltages, V

are V

R

components which determine output voltage levels have ac-

curate ratios, their absolute values may be controlled only

justment, output voltages are well controlled. A final design

should accommodate the variation in externally set output

voltages due to the CLC006’s part-to-part and external com-

ponent tolerances.

Output voltage swing may be reduced with the circuit shown

in

Figure 9. A single resistance chosen with the aid of the

graph,

Figure 10, is connected between pins 3 and 4. Output

voltage swing may be increased with the circuit of

Figure 11.

Figure 12 is used to estimate a value for resistor R. Note that

both of these circuits and the accompanying graphs assume

that the CLC006 is loaded with the standard 150

Ω. Be aware

that output loading will affect the output swing and the high

and low levels. It may be necessary to empirically select re-

sistances used to set output levels when the D.C. loading on

the CLC006 differs appreciably from 150

Ω.

DS100084-10

FIGURE 7. Differential Input DC Coupled Output

DS100084-11

FIGURE 8. Equivalent Bias Generation Circuit

5

www.national.com