ASBSM4-LED3 datasheet(8/178 Pages) LUMBERG

8 / 178 page

1-717-217-2299

www.lumberg-automationusa.com

Enclosure~less Wiring Solution for On-Machine Applications

Legend

1. Passive Distribution Boxes

Many styles to choose from. 4-, 6-, or 8-ports, top or side entry, with on-board, homerun

cable, or quick-disconnect connector.

2. Cordsets

Single- and Double-Ended Cordsets provide connection between field devices and the

ports of a distribution box or may be used to hardwire a device to a control panel or

distribution box.

3. Receptacles

Receptacles are connectors that mount in a fixed location (sensor or panel) and mate with

a molded cable.

4. Field Attachable Connectors

Used to complete the assembly of a single-ended cordset. Field attachables are available in

a variety of thread sizes and number of poles, straight and right-angle or to make cordset

repairs in the field.

5. DIN Valve Connectors

Are mainly used with solenoid valves in hydraulic and pneumatic applications. In addition,

these connectors are also used in electrical applications for pressure switches, filter

switches, limit switches and special sensors.

6. Splitters

Devices that provide the means of bringing two different sensor/actuator signals into a

single port of an ASB distribution box, thereby doubling the capacity of the box.

7. Fieldbus I/O Blocks

Have embedded communications protocol, e.g., DeviceNet, Profibus...) that allows them to

actively communicate with the network interface at the PLC.

8. Fieldbus I/O Modular Bus Systems

Are systems with bus-neutral I/O modules and communications adapters that allow the

designer to mix and match field bus and I/O hardware components as needed for the

application.

9. Bus Taps and Tees

Connect drop lines to the main trunk line or combine power and signal using a

hybrid cable.

10. Drop and Trunk Cordsets

When connecting multiple devices to a single communications trunk, the trunk is split with

a T-connector. The cable that connects the device to the main trunk is referred to as a

drop cable.

11. Terminating Resistors

Are placed at the end of a transmission line or daisy chain bus (such as in Devicenet),

designed to match impedance and hence minimize signal reflections.

Active/Passive Application Diagram

ASBSM4-LED3 数据表(PDF) 8 Page - Lumberg

ASBSM4-LED3 数据表(HTML) 8 Page - Lumberg

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

数据表下载