Page 2/13

www.lem.com

HLSR-P series

Absolute maximum ratings

Parameter

Symbol

Unit

Value

Supply voltage (not destructive)

U

C

V

8

Supply voltage (not entering non standard modes)

U

C

V

6.5

Jumper temperature

T

B

°C

120

ESD rating, Human Body Model (HBM)

U

ESD

kV

2

Stresses above these ratings may cause permanent damage. Exposure to absolute maximum ratings for extended periods may

degrade reliability.

UL 508: Ratings and assumptions of certification

File # E189713 Volume: 2 Section: 5

Standards

● CSA C22.2 NO. 14-10 INDUSTRIAL CONTROL EQUIPMENT - Edition 11 - Revision Date 2011/08/01

● UL 508 STANDARD FOR INDUSTRIAL CONTROL EQUIPMENT - Edition 17 - Revision Date 2010/04/15

Ratings

Parameter

Symbol

Unit

Value

Primary involved potential

V AC/DC

600

Max surrounding air temperature

T

A

°C

85

Primary current

I

P

A

According to series primary

current

Secondary supply voltage

U

C

V DC

5

Output voltage

V

out

V

0 to 5

Conditions of acceptability

1 - These devices have been evaluated for overvoltage category III and for use in pollution degree 2 environment.

2 - A suitable enclosure shall be provided in the end-use application.

3 - The terminals have not been evaluated for field wiring.

4 - These devices are intended to be mounted on a printed wiring board of end use equipment. The suitability of the

connections (including spacings) shall be determined in the end-use application.

5 - Primary terminals shall not be straightened since assembly of housing case depends upon bending of the terminals.

6 - Any surface of polymeric housing have not been evaluated as insulating barrier.

7 - Low voltage control circuit shall be supplied by an isolating source (such as a transformer, optical isolator,

limiting impedance or electro-mechanical relay).

Marking

Only those products bearing the UR Mark should be considered to be Listed or Recognized and covered under UL's Follow-Up

Service. Always look for the Mark on the product.