LF06A-P datasheet(2/4 Pages) OSRAM

2 / 4 page

www.osram.com/flex

Due to the special conditions of manufacturing processes of LED, the typical data of technical parameters can only reflect statistical figures and do not necessarily

correspond to the actual parameters of each single product which could differ from the typical data.

Subject to change without notice. Errors and omissions excepted. Version: 2014-05-06

LINEARlight Flex® Protect ADVANCED G2 – LF06A-P

2/4

Technical operating data (for overall module)

Product

Order Code

Voltage

[V]

Power

[W]

Current

[A]

Luminous

Flux [lm]

Radiance

Angle [°]

Overall

Length

LF06A-W3F-830-P

4008321789983

3500

120

10 m

LF06A-W3F-840-P

4008321790125

3900

120

10 m

LF06A-W3F-870-P

4008321790149

3900

120

10 m

Minimum & maximum ratings

Operating temperature

at Tc-Point [°C]

Storage temperature

[°C]

Voltage range

[V dc]

Reverse Voltage

[V dc]

LF06A

20 … +70°C

40 … +100°C

23 … 25 V

25 V

► Exceeding maximum ratings for operating and storage temperature will reduce expected life time or destroy the LED Module.

► Exceeding maximum ratings for operating voltage will cause hazardous overload and will likely destroy the LED Module.

► The temperature of the LED module must be measured at the Tc-point according to EN60598-1 in a thermally constant status with a

temperature sensor or a temperature sensitive label. For exact location of the Tc-point see drawing below.

Technical drawing

Safety information

► The module has to be protected from mechanical loads

► Assembly must not damage or destroy conducting paths on the circuit board.

► Installation of LED modules (with power supplies) needs to be made with regard to all applicable and safety standards. Only qualified

personnel should be allowed to perform installations.

► Observe correct polarity!

Depending on the product incorrect polarity will lead to emission of no light. The module can be damaged after a few seconds. To prevent

this, correct polarity immediately! (see "reverse voltage", page 2)

► Parallel connection is highly recommended as safe electrical operation mode.

Serial connection is not recommended. Unbalanced voltage drop can cause hazardous overload the LED module.

► ESD protection methods have to be observed when cutting and connecting the module. on ESD handling in the application note ESD

protection for LED modules.

► The LED Module must not be operated under water

► Please ensure that the power supply is of adequate power to operate the total load.

16.7 mm

LF06A-P 数据表(PDF) 2 Page - OSRAM GmbH

LF06A-P 数据表(HTML) 2 Page - OSRAM GmbH

Html Pages

1 2 3 4

数据表下载

链接网址

LF06A-P 数据表(PDF) 2 Page - OSRAM GmbH

LF06A-P 数据表(HTML) 2 Page - OSRAM GmbH

Html Pages

1 2 3 4

数据表 下载

链接网址

数据表下载