ADS7828

14

SBAS181C

www.ti.com

If the PD1 bit has been set to logic ‘0’ while using the

ADS7828, then the settling time must be reconsidered

after PD1 is set to logic ‘1’. In other words, whenever the

internal reference is turned on after it has been turned off,

the settling time must be long enough to get 12-bit accu-

racy conversion.

3) When the internal reference is off, it is not turned on until

both the first Command Byte with PD1 = ‘1’ is sent

and

then a STOP condition or repeated START condition is

issued. (The actual turn-on time occurs once the STOP or

repeated START condition is issued.) Any Command Byte

with PD1 = ‘1’ issued after the internal reference is turned

on serves only to keep the internal reference on. Other-

wise, the internal reference would be turned off by any

Command Byte with PD1 = ‘0’.

The example in Figure 5 can be generalized for a HS mode

conversion cycle by simply swapping the timing of the con-

version cycle.

If using an external reference, PD1 must be set to ‘0’, and the

external reference must be settled. The typical sequence in

Figure 3 or Figure 4 can then be used.

READING WITH REFERENCE ON/OFF

The internal reference defaults to off when the ADS7828

power is on. To turn the internal reference on or off, see

Table I. If the reference (internal or external) is constantly

turned on and off, a proper amount of settling time must be

added before a normal conversion cycle can be started. The

exact amount of settling time needed varies depending on

the configuration.

See Figure 5 for an example of the proper internal reference

turn-on sequence before issuing the typical read sequences

required for the F/S mode when an internal reference is

used.

When using an internal reference, there are three things that

must be done:

1) In order to use the internal reference, the PD1 bit of

Command Byte must always be set to logic ‘1’ for each

sample conversion that is issued by the sequence, as

shown in Figure 3.

2) In order to achieve 12-bit accuracy conversion when

using the internal reference, the internal reference

settling time must be considered, as shown in the

FIGURE 5. Internal Reference Turn-On Sequence and Typical Read Sequence (F/S mode shown).

Sr

A1

100

1

0

A0

R

A

00

00

D11 D10 D9 D8

AD7 D6 . . .D1 D0

NP

SA1

10

01

1

0A0

W

ASD

C2 C1 C0

PD0 XXA

SA1

10

01

1

0A0

W

AX

X

X

X

X

XX

A

P

Wait until the required

settling time is reached

Internal Reference Turn-On Sequence

Settled Internal Reference

Settled Internal Reference

Internal Reference

Turn-On

Settling Time

Typical Read

in F/S Mode

From Master to Slave

A = acknowledge (SDA LOW)

N = not acknowledge (SDA HIGH)

S = START Condition

P = STOP Condition

Sr = repeated START condition

W = '0' (WRITE)

R = '1' (READ)

From Slave to Master

Command Byte

Write-Addressing Byte

Command Byte

Write-Addressing Byte

ADC Power-Down Mode

ADC Sampling Mode

ADC Converting Mode

ADC Power-Down Mode

(depending on power-down selection bits)

Read-Addressing Byte

2 x (8 Bits + ack/not-ack)

see

note

(2)

NOTES: (1) Typical read sequences can be reused after the internal reference is settled.

(2) To secure bus operation and loop back to the stage of write-addressing for next conversion, use repeated START.