bq20z95

www.ti.com

SLUS757C – JULY 2007 – REVISED OCTOBER 2013

FEATURE SET

Primary (1st Level) Safety Features

The bq20z95 supports a wide range of battery and system protection features that can easily be configured. The

primary safety features include:

•

Cell over/undervoltage protection

•

Charge and discharge overcurrent

•

Short circuit

•

Charge and discharge overtemperature

•

AFE watchdog

Secondary (2nd Level) Safety Features

The secondary safety features of the bq20z95 can be used to indicate more serious faults via the SAFE (pin 7).

This pin can be used to blow an in-line fuse to permanently disable the battery pack from charging or

discharging. The secondary safety protection features include:

•

Safety overvoltage

•

Safety overcurrent in Charge and Discharge

•

Safety overtemperature in Charge and Discharge

•

Charge FET and 0-V Charge FET fault

•

Discharge FET fault

•

AFE communication fault

Charge Control Features

The bq20z95 charge control features include:

•

Reports the appropriate charging current needed for constant current charging and the appropriate charging

voltage needed for constant voltage charging to a smart charger using SMBus broadcasts.

•

Determines the chemical state of charge of each battery cell using Impedance Track and can reduce the

charge difference of the battery cells in fully charged state of the battery pack gradually using cell balancing

algorithm during charging. This prevents fully charged cells from overcharging and causing excessive

degradation and also increases the usable pack energy by preventing premature charge termination

•

Supports pre-charging/zero-volt charging

•

Support fast charging

•

Supports charge inhibit and charge suspend if battery pack temperature is out of temperature range

•

Reports charging fault and also indicate charge status via charge and discharge alarms.

Gas Gauging

The bq20z95 uses the Impedance Track technology to measure and calculate the available charge in battery

cells. The achievable accuracy is better than 1% error over the lifetime of the battery and there is no full charge

discharge learning cycle required.

See Theory and Implementation of Impedance Track Battery Fuel-Gauging Algorithm application note (SLUA364)

for further details.

Authentication

The bq20z95 supports authentication by the host using SHA-1.

Copyright © 2007–2013, Texas Instruments Incorporated

Submit Documentation Feedback

11

Product Folder Links: bq20z95