CDC208DBLE datasheet(3/18 Pages) TI1

3 / 18 page

CDC208

DUAL 1LINE TO 4LINE CLOCK DRIVER

WITH 3STATE OUTPUTS

SCAS109F − APRIL 1990 − REVISED OCTOBER 1998

POST OFFICE BOX 655303

• DALLAS, TEXAS 75265

absolute maximum ratings over operating free-air temperature range (unless otherwise noted)†

Supply voltage range, VCC

−0.5 V to 7 V

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Input voltage range, VI (see Note 1)

−0.5 V to VCC + 0.5 V

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Output voltage range, VO (see Note 1)

−0.5 V to VCC + 0.5 V

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Input clamp current, IIK (VI < 0 or VI > VCC)

±20 mA

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Output clamp current, IOK (VO < 0 or VO > VCC)

±50 mA

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Continuous output current, IO (VO = 0 to VCC)

±50 mA

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Continuous current through VCC or GND

±200 mA

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Maximum power dissipation at TA = 55°C (in still air) (see Note 2)

1.6 W

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Storage temperature range

−65

°C to 150°C

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

† Stresses beyond those listed under “absolute maximum ratings” may cause permanent damage to the device. These are stress ratings only, and

functional operation of the device at these or any other conditions beyond those indicated under “recommended operating conditions” is not

implied. Exposure to absolute-maximum-rated conditions for extended periods may affect device reliability.

NOTES:

1. The input and output negative-voltage ratings may be exceeded if the input and output clamp-current ratings are observed.

2. The maximum package power dissipation is calculated using a junction temperature of 150

°C and a board trace length of 750 mils.

For more information, refer to the Package Thermal Considerations application note in the 1994 ABT Advanced BiCMOS Technology

Data Book, literature number SCBD002B.

recommended operating conditions

MIN

NOM

MAX

UNIT

VCC

Supply voltage

4.5

5.5

VIH

High-level input voltage

VIL

Low-level input voltage

0.8

Input voltage

VCC

IOH

High-level output current

−24

IOL

Low-level output current

∆t/∆v

Input transition rise or fall rate

ns / V

fclock

Input clock frequency

MHz

Operating free-air temperature

−40

°C

CDC208DBLE 数据表(PDF) 3 Page - Texas Instruments

CDC208DBLE 数据表(HTML) 3 Page - Texas Instruments

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18

数据表下载