non

-Qml

/eS

Pre-cap Inspection

Method 2017, 2032

n

n

Temperature Cycle (10 times)

Method 1010, Cond. B, -55°C to +125°C, ambient

n

Constant Acceleration

Method 2001, 500 g

n

Burn-in

96 hours

n

Final Electrical Test MIL-PRF-38534, Group A

Subgroups 1 and 4: +25°C case

n

n

Hermeticity Test

Fine Leak, Method 1014, Cond. A

n

Gross Leak, Method 1014, Cond. C

n

Gross Leak, Dip

n

Final visual inspection

Method 2009

n

n

Test methods are referenced to MIL-STD-883 as determined by MIL-PRF-38534.

Notes:

1. “Non-QML” Refers to products that do not offer QML screening.

2. Standard and /ES, non-QML products, may not meet all of the requirements of MIL-PRF-38534.

3. Burn-in temperature designed to bring the case temperature to the maximum case temperature of the product. Refer to the specific

product information for the maximum case temperature. Burn-in is a powered test.

Crane Aerospace & Electronics Power Solutions

Quality Assurance and Certification

APPLICATION NOTE

Page 11 of 13

APP-009 Rev AB - 2014.01.28

www.craneae.com/interpoint

Crane Aerospace & Electronics Power Solutions

FMD28-461 EMI Input Filters, FMD28 Rev AA - 2014.02.06. This revision supersedes all previous releases. All technical information is believed to be

accurate, but no responsibility is assumed for errors or omissions. Crane Electronics, Inc. reserves the right to make changes in products or speci-

fications without notice. Interpoint is a registered trademark of Crane Co. and FMD28 Series is a trademark of Crane Electronics, Inc. Copyright ©

1999 - 2014 Crane Electronics, Inc. All rights reserved. www.craneae.com/interpoint

Page 8 of 8

FMD28-461 eMi input Filters

28 Volt input – 7 aMp