TNETV2685FIBZUT11 datasheet(115/190 Pages) TI1

115 / 190 page

AECLKOUT

AARDY(A)

ASSERTED

DEASSERTED

Strobe

Hold = 2

Extended Strobe

Strobe

Setup = 2

TMS320DM647

TMS320DM648

www.ti.com

SPRS372H – MAY 2007 – REVISED APRIL 2012

Polarity of the AARDY signal is programmable through the AP field of the EMIFA Async Wait Cycle Configuration

Figure 6-23. AARDY Timing

6.10.3.2 Programmable Synchronous Interface Timing

Table 6-46. Timing Requirements for Programmable Synchronous Interface Cycles for EMIFA Module

(see Figure 6-24)

720, 800, 900, 1100

NO.

UNIT

MIN

MAX

tsu(EDV-EKOH)

Setup time, read AEDx valid before AECLKOUT high

th(EKOH-EDV)

Hold time, read AEDx valid after AECLKOUT high

1.5

Table 6-47. Switching Characteristics Over Recommended Operating Conditions for Programmable

Synchronous Interface Cycles for EMIFA Module(1) (see Figure 6-24-Figure 6-26)

720, 800, 900, 1100

NO.

PARAMETER

UNIT

MIN

MAX

td(EKOH-CEV)

Delay time, AECLKOUT high to ACEx valid

1.3

4.9

td(EKOH-BEV)

Delay time, AECLKOUT high to ABEx valid

4.9

td(EKOH-BEIV)

Delay time, AECLKOUT high to ABEx invalid

1.3

td(EKOH-EAV)

Delay time, AECLKOUT high to AEAx valid

4.9

td(EKOH-EAIV)

Delay time, AECLKOUT high to AEAx invalid

1.3

td(EKOH-ADSV)

Delay time, AECLKOUT high to ASADS/ASRE valid

1.3

4.9

td(EKOH-OEV)

Delay time, AECLKOUT high to AAOE/ASOE valid

1.3

4.9

td(EKOH-EDV)

Delay time, AECLKOUT high to AEDx valid

4.9

td(EKOH-EDIV)

Delay time, AECLKOUT high to AEDx invalid

1.3

td(EKOH-WEV)

Delay time, AECLKOUT high to AAWE/ASWE valid

1.3

4.9

(1)

The following parameters are programmable via the EMIFA CE Configuration registers (CEnCFG):

•

Read latency (R_LTNCY): 0-, 1-, 2-, or 3-cycle read latency

•

Write latency (W_LTNCY): 0-, 1-, 2-, or 3-cycle write latency

•

ACEx assertion length (CE_EXT): For standard SBSRAM or ZBT SRAM interface, ACEx goes inactive after the final command has

been issued (CE_EXT = 0). For synchronous FIFO interface with glue, ACEx is active when AAOE/ASOE is active (CE_EXT = 1).

•

Function of ASADS/ASRE (R_ENABLE): For standard SBSRAM or ZBT SRAM interface, ASADS/ASRE has deselect cycles

(R_ENABLE = 0). For FIFO interface, ASADS/ASRE has NO deselect cycles (R_ENABLE = 1).

Peripheral Information and Electrical Specifications

115

Submit Documentation Feedback

Product Folder Link(s): TMS320DM647 TMS320DM648

TNETV2685FIBZUT11 数据表(PDF) 115 Page - Texas Instruments

TNETV2685FIBZUT11 数据表(HTML) 115 Page - Texas Instruments

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

数据表下载