TNETE2201B

1.25GIGABIT ETHERNET TRANSCEIVER

SLLS367D − JUNE 1999 − REVISED AUGUST 2007

7

POST OFFICE BOX 655303

data reception (continued)

During a bus error condition or word alignment, the receive byte clocks RBC0 and RBC1 are stretched (never

truncated). When the incoming serial data does not meet its frequency requirements, then the receive byte clock

frequency is maintained at 62.5 MHz.

receive PLL operation

The receive PLL provides automatic locking to the incoming data. At power up, the maximum initial lock time

is 500

µs. The PLL can also be initiated or set to phase lock to the externally supplied reference clock by enabling

lock-to-reference (LCKREFN). The lock-to-reference causes the receive PLL to lock to 10

× the reference clock

(REFCLK) input providing a PLL preset and reset capability.

If during normal operation a transient occurs, which is defined as any arbitrary phase shift in the incoming data

and/or a frequency wander of up to 200 ppm, then the PLL recovers lock within 2.4

µs. Any condition exceeding

these values is considered a power-up scenario and the PLL recovers lock within 500

µs with a 0.1 µF capacitor

the PLL recovers lock within 10 ms on power up (see the following note).

NOTE:

A filter capacitor value of 0.1

µF can be used with the following consideration: The tracking

bandwidth of the PLL will be reduced due to the larger filter capacitor. This reduces the transmit and

receive PLL’s ability to reject low-frequency noise or wonder in the voltage supply or datastream.

to reject power supply noise.

receiver word alignment

The TNETE2201B uses a 10-bit K28.5 character (comma character) word alignment scheme. The following

sections explain how this scheme works and how it realigns itself.

comma character on expected boundary

The TNETE2201B provides 10-bit K28.5 character recognition and word alignment. The 10-bit word alignment

is enabled by forcing SYCNEN high. This enables the function that examines and compares ten bits of serial

input data to the K28.5 synchronization character. The K28.5 character is defined in the fibre channel standard

as a pattern consisting of 0011111010 (a negative number beginning disparity) with the 7 MSBs (0011111)

referred to as the comma character. The K28.5 character was implemented specifically for aligning data words.

As long as the K28.5 character falls within the expected 10-bit word boundary, the received 10-bit data is

properly aligned and data realignment is not required. Figure 1 shows the timing characteristics of RBC0, RBC1,

SYNC and RD0 − RD9 while synchronized.

NOTE:

The

K28.5 character is valid on the rising edge of RBC1.

RBC0

RD0 − RD9

RBC1

SYNC

K28.5

Dxx.x

Dxx.x

Dxx.x

K28.5

Dxx.x

Figure 1. Synchronous Timing Characteristics Waveforms