CS10.481

C–Series

Nov. 2006 / Rev.1.1 DS-CS10.481-EN

All parameters are specified at 48V, 5A, 230Vac, 25°C ambient and after a 5 minutes run-in time unless otherwise noted.

www.pulspower.com Phone +49 89 9278 0

Germany

8/20

Fig. 12-1 Front side

Output voltage potentiometer

Open the flap to tune the output voltage.

Factory set: 48.0V

Output Terminals

Screw terminals

+

Positive output

-

Negative (return) output

Dual pins per pole

Input Terminals

Screw terminals

N … Neutral input

L … Line (hot) input

... PE (Protective Earth) input

DC-on lamp (green)

On when the voltage on the output

terminals is > 37V

Type

Screw terminals

Solid wire

0.5-6mm

2

Stranded wire

0.5-4mm

2

American wire gauge

20-10 AWG

Ferrules

allowed, but not required

Wire stripping length

7mm / 0.275inch

Screwdriver

3.5mm slotted or Pozidrive No 2

Recommended tightening torque

0.8Nm, 7lb.in

Instructions:

a)

Use appropriate copper cables that are designed for an operating temperature of:

60°C for ambient up to 45°C and

75°C for ambient up to 60°C minimum.

b)

Follow national installation codes and installation regulations!

c)

Ensure that all strands of a stranded wire enter the terminal connection!

d)

Up to two stranded wires with the same cross section are permitted in one connection point (except PE wire).

e)

Do not use the unit without PE connection.