4/21

As of July 2016

SFD16M034

• When [GEOMETRY] is used, the focus of the entire screen may be lost as correction increases.

• Make the curved screen a circular arc shape with one part of a perfect circle removed.

• Adjustment range of the [GEOMETRY] items may not match the listed projection range depending

on the projection lens. Use this projector within the projection range, otherwise the correction may

not work.

Optical axis shift

Vertical: +50%, -16%(powered),

Horizontal: +30%, -10%(When using the ET-DLE085, +28%, -10

％) (powered)

Screen

Projection distance

Arc radius

Screen

Projection distance

Arc radius

Arc center

Screen

Projection distance

Arc radius

Arc center

Screen

Projection distance

Arc radius

Geometry correction range

Installation

Ceiling/floor, front/rear, 360 degree free installation

DLP™ Projector

PT-RZ970B/RZ970W/RZ970LB/RZ970LW

NOTE: Optical axis shift function cannot be operated when used with the ET-DLE055.

If using the ET-DLE030, the optical axis is fixed.

Terminals

SDI IN

HDMI IN

DVI-D IN

RGB 1 IN

R, G, B

Y,

Y,C

Video

RGB 2 IN

R, G, B

BNC × 1,

3G-SDI signal: SMPTE ST 424 compliant

HD-SDI signal: SMPTE ST 292 compliant

SD-SDI signal: SMPTE ST 259 compliant

HDMI 19-pin × 1, Deep Color, compatible with HDCP,

DVI-D 24-pin x 1, DVI 1.0 compliant, compatible with HDCP,

for single link only

BNC ×5

R: 0.7 Vp-p, 75 ohms,

G: 0.7 Vp-p (G: 1.0 Vp-p for sync on G), 75 ohms,

B: 0.7 Vp-p, 75 ohms

HD, VD/SYNC: TTL, high impedance, positive/negative automatic

Y:

Y: 1.0 Vp-p, C: 0.286 Vp-p, 75 ohms

1.0Vp-p, 75 ohms

D-sub HD 15-pin (female) ×1

R: 0.7 Vp-p, 75 ohms,

G: 0.7 Vp-p (G: 1.0 Vp-p for sync on G), 75 ohms,

B: 0.7 Vp-p, 75 ohms

HD, VD/SYNC: TTL, high impedance, positive/negative automatic

REMOTE 2 IN

D-sub 9-pin (female) x1 for external control (parallel)

SERIAL/MULTI

PROJECTOR SYNC IN

SERIAL/MULTI

PROJECTOR SYNC OUT

REMOTE 1 IN

REMOTE 1 OUT

D-sub 9-pin (female) ×1 for external control (RS-232C compliant)

D-sub 9-pin (male) x 1 for link control

M3 jack x 1 for wired remote control

M3 jack x 1 for link control (for wired remote control)

LAN/DIGITAL LINK

RJ-45 x 1 for network and DIGITAL LINK (video/network/serial control)

connection, 100Base-TX, compliant with PJLink™(Class 1)

Deep Color, HDCP

Vertical arc correction (viewed from the side)

Horizontal arc correction (viewed from above)