UCD3138ARMHT datasheet(22/87 Pages) TI1

22 / 87 page

Start of Period

Period Counter

Start of Period

Period

Sample Trigger 1

DPWM Output A

Cycle Adjust A (High Resolution)

Event 2 (High Resolution)

Event 1

Event 3 (High Resolution)

Cycle Adjust B (High Resolution)

Event 4 (High Resolution)

DPWM Output B

Blanking A Begin

Blanking A End

Blanking B Begin

Blanking B End

Phase Trigger

Sample Trigger 2

To Other

Modules

To Other

Modules

UCD3138A

SLUSC66C – MARCH 2015 – REVISED SEPTEMBER 2016

www.ti.com

Submit Documentation Feedback

Product Folder Links: UCD3138A

Specifications

The Sample Trigger signals are used to trigger the front end to sample input signals. The Blanking signals

are used to blank fault measurements during noisy events, such as FET turn on and turn off.

Events which change with DPWM mode:

•

DPWM A Rising Edge = Event 1

•

DPWM A Falling Edge = Event 2 + Cycle Adjust A

•

DPWM B Rising Edge = Event 3

•

DPWM B Falling Edge = Event 4 + Cycle Adjust B

•

Phase Trigger = Phase Trigger Register value or Filter Duty

Events always set by their registers, regardless of mode:

•

Sample Trigger 1, Sample Trigger 2, Blanking A Begin, Blanking A End, Blanking B

•

Begin, Blanking B End

Figure 5-5. Multi Mode Open Loop

UCD3138ARMHT 数据表(PDF) 22 Page - Texas Instruments

UCD3138ARMHT 数据表(HTML) 22 Page - Texas Instruments

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87

数据表下载