FEDL620Q130-02

ML620Q131/2/3/4/5/6

2/33

· Timers

‒ 8 bits x 10 ch (16-bit configuration available)

‒ Continuous timer mode/one-shot timer mode

‒ Timer start/stop function by software/external trigger input

· PWM

‒ Resolution 16 bits x 1 ch

‒ Continuous PWM mode/one-shot PWM mode

‒ PWM start/stop function by software/external trigger input

· Synchronous serial port

‒ Master/slave selectable

‒ LSB first/MSB first selectable

‒ 8-bit length/16-bit length selectable

‒ Operation in the SPI mode 0/3

‒ Overflow detection function

· UART

‒ Full-duplex communication x 1 ch

‒ Bit length, parity/no parity, odd parity/even parity, 1 stop bit/2 stop bits

‒ Positive logic/negative logic selectable

‒ Internal baud rate generator

‒ Master x 1ch

Standard mode (100 kbit/s) and fast mode (400 kbit/s) are supported

‒ Slave x 1ch

Standard mode (100 kbit/s) and fast mode (400 kbit/s) are supported

· Successive approximation type A/D converter

‒ 10-bit A/D converter

‒ ML620Q131/ ML620Q132/ ML620Q133 : Input 6 ch

‒ ML620Q134/ ML620Q135/ML620Q136 : Input 8 ch

· Analog Comparator

‒ Operation voltage range: VDD = 1.8 to 5.5 V

‒ Hysteresis width (only comparator 0): 20 mV (Typ.)

‒ Interrupts allow edge selection and sampling selection

· DUTY measurement circuit

‒ DUTY ratio measurement by inputting PWM signals with frequencies from 2 KHz to 64 KHz

‒ DUTY measurement interrupt: 4 types selectable (64 µs, 0.51 ms, 1.09 ms, 2.18 ms)

· General-purpose ports （including secondary functions）

‒ Input-only port

1 ch (including secondary functions, also used by the on-chip debug pin)

‒ I/O port

ML620Q131/ML620Q132/ML620Q133: 10 ch (including secondary functions)

ML620Q134/ML620Q135/ML620Q136: 14 ch (including secondary functions)