MCP3909-ESLASHSS datasheet(29/44 Pages) MICROCHIP

29 / 44 page

 2006-2012 Microchip Technology Inc.

DS22025C-page 29

MCP3909

5.7

Using the MCP3909 with

Microcontroller (MCU) SPI Ports

With microcontroller SPI ports, it is required to send

groups of eight bits. It is also required that the micro-

controller SPI port be configured to clock out data on

the falling edge of clock and latch data in on the rising

edge, or vice versa depending on the mode.

5.7.1

SPI MODE DEFINITIONS

The following table represents the standard SPI mode

terminology, the respective PIC bit settings, and a

description of compatibility for the MCP3909 device.

The MCP3909 works in SPI mode 0,1 mode, that is the

data is clocked out of the part on the rising edge and

clocked in on the falling edge of SCK.

TABLE 5-4:

SPI MODE COMPATIBILITY

Standard SPI

Mode

Terminology

PIC Control Bits

State

MCP3909

Compatibility

Description

CKP

CKE

0,0

—

Idle state for clock is low level, transmit (from PIC)

occurs from active to idle clock state

0,1

√

Idle state for clock is low level, transmit (from PIC)

occurs from idle to active clock state

1,0

—

Idle state for clock is high level, transmit (from PIC)

occurs from active to idle clock state

1,1

—

Idle state for clock is high level, transmit (from PIC)

occurs from idle to active clock state

MCP3909-E/SS 数据表(PDF) 29 Page - Microchip Technology

MCP3909-E/SS 数据表(HTML) 29 Page - Microchip Technology

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44

数据表下载