K Hours

---

---

1000

MIL-HDBK-217F @ 25], Ground Benign

MTBF

]

117

112

107

Case Temperature, automatic recovery

Over Temperature Protection

KHz

360

330

290

Switching Frequency

pF

1500

1200

---

100KHz,1V

Isolation Capacitance

M[

---

---

1000

500VDC

Isolation Resistance

VDC

---

---

1650

Flash Tested for 1 Second

Isolation Voltage Test

VDC

---

---

1500

60 Seconds

Isolation Voltage Rated

Unit

Max.

Typ.

Min.

Conditions

Parameter

General Specifications

Continuous

Output Short Circuit

%/]

{0.02

{0.01

---

Temperature Coefficient

%

{4

{2

---

Transient Response Deviation

uS

300

150

---

25% Load Step Change

Transient Recovery Time

%

180

---

120

Over Power Protection

mV rms

10

---

---

Ripple & Noise (20MHz)

mV P-P

100

---

---

Over Line, Load & Temp.

Ripple & Noise (20MHz)

mV P-P

80

55

---

Ripple & Noise (20MHz)

%

{1.0

{0.3

---

Io=50% to 100%

Load Regulation

%

{0.5

{0.2

---

Vin=Min. to Max.

Line Regulation

%

{2.0

{0.5

---

Dual Output, Balanced Loads

Output Voltage Balance

%

{1.0

{0.5

---

Output Voltage Accuracy

Unit

Max.

Typ.

Min.

Conditions

Parameter

Output Specifications

Referenced to Negative Input

Control Common

uA

-100

---

---

Vin -RC = 0V

Control Input Current ( off )

uA

5

---

---

Vin -RC = 5.0V

Control Input Current ( on )

mA

5

2

---

Device Standby Input Current

VDC

1

---

-1

Supply Off

VDC

2.5 to 100VDC or Open Circuit

Supply On

Unit

Max.

Typ.

Min.

Conditions

Parameter

Remote On/Off Control

%

{11.0

{10.0

{9.0

% of nominal output voltage

Trim Up / Down Range

Unit

Max.

Typ.

Min.

Conditions

Parameter

Output Voltage Trim

Notes1:

1. Specifications typical at Ta=+25], resistive load, nominal input voltage, rated output current unless otherwise noted.

2. Transient recovery time is measured to within 1% error band for a step change in output load of 75% to 100%.

3. Ripple & Noise measurement bandwidth is 0-20 MHz.

4. These power converters require a minimum output loading to maintain specified regulation.

5. Operation under no-load conditions will not damage these modules; however, they may not meet all specifications listed.

6. All DC/DC converters should be externally fused at the front end for protection.

7. Other input and output voltage may be available, please contact factory.

8. Specifications subject to change without notice.

MPW2000 Series

Total Power International, Inc.

Toll Free: 877-646-0900(US)

www.total-power.com