Voltage

Comparator

AS111

Micross Components reserves the right to change products or specifications without notice.

4

AS111

Rev. 1.7 01/10

Note 6: These specifications apply for VS=±15V and Ground pin at ground, and -55°C < T

stated. The offset voltage, offset current and bias current specifications apply for any supply voltage from a single 5V supply

up to ±15V supplies.

Note 7: The offset voltages and offset currents given are the maximum values required to drive the output within a volt of

either supply with a 1mA load. Thus, these parameters define an error band and take into account the worst-case effects of

voltage gain and R

Note 8: The response time specified (see definitions) is for a 100 mV input step with 5 mV overdrive.

Note 9: This specification gives the range of current which must be drawn from the strobe pin to ensure the output is properly

disabled. Do not short the strobe pin to ground; it should be current driven at 3 to 5 mA.