MCP79412 datasheet(21/66 Pages) MICROCHIP

21 / 66 page

 2010-2016 Microchip Technology Inc.

DS20002266H-page 21

MCP79410/MCP79411/MCP79412

5.4

Alarms

The MCP7941X features two independent alarms. Each

alarm can be used to either generate an interrupt at a

specific time in the future, or to generate a periodic

interrupt every minute, hour, day, day of week, or month.

There is a separate interrupt flag, ALMxIF, for each alarm.

The interrupt flags are set by hardware when the chosen

alarm mask condition matches (Table 5-5). The interrupt

flags must be cleared in software.

If either alarm module is enabled by setting the

corresponding ALMxEN bit in the CONTROL register, and

if the square wave clock output is disabled (SQWEN = 0),

then the MFP will operate in Alarm Interrupt Output mode.

Refer to Section 5.5 “Output Configurations” for

details. The alarm interrupt output is available while

operating from the backup power supply.

Both Alarm0 and Alarm1 offer identical operation. All time

and date values are stored in the registers as

binary-coded decimal (BCD) values.

TABLE 5-5:

ALARM MASKS

FIGURE 5-6:

ALARM BLOCK DIAGRAM

Note:

Throughout this section, references to the

modules are referred to generically by the

use of ‘x’ in place of the specific module

number. Thus, “ALMxSEC” might refer to

the seconds register for Alarm0 or Alarm1.

ALMxMSK<2:0>

Alarm Asserts on Match of

000

Seconds

001

Minutes

010

Hours

011

Day of Week

100

Date

101

Reserved

110

Reserved

111

Seconds, Minutes, Hours,

Day of Week, Date, and Month

Note 1:

The alarm interrupt flags must be cleared

by the user. If a flag is cleared while the

corresponding

alarm

condition

still

matches, the flag will be set again,

generating another interrupt.

Loading invalid values into the alarm

registers

will

result

undefined

operation.

MFP

RTCSEC

RTCMIN

RTCHOUR

RTCWKDAY

RTCDATE

RTCMTH

Timekeeping

Registers

ALM1SEC

ALM1MIN

ALM1HOUR

ALM1WKDAY

ALM1DATE

ALM1MTH

Alarm1

Registers

ALM0SEC

ALM0MIN

ALM0HOUR

ALM0WKDAY

ALM0DATE

ALM0MTH

Alarm0

Registers

Alarm0 Mask

Alarm1 Mask

Comparator

MFP Output Logic

Set

ALM0IF

Set

ALM1IF

ALM0MSK<2:0>

ALM1MSK<2:0>

MCP79412 数据表(PDF) 21 Page - Microchip Technology

MCP79412 数据表(HTML) 21 Page - Microchip Technology

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66

数据表下载

链接网址

MCP79412 数据表(PDF) 21 Page - Microchip Technology

MCP79412 数据表(HTML) 21 Page - Microchip Technology

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66

数据表 下载

链接网址

数据表下载