LOC B

Figure 3

2.3. Die Insertion Pneumatic Tool No. 69270-1 Mod.2

Dies are coated with oil to prevent rust and corrosion.

Wipe this oil from dies, particularly from Crimping

area.

Pneumatic tool No. 69270-1, Model 2 is equipped with

a pneumatic die take-up lever. See Figure 3. This

1. Each set of dies consists of a male die and a

female die. See Figure 4.

3. Pull female die holding pin out of tool. Depress

take-up lever until male die holding screw is

visible, See Figure

4. With take-up lever depressed, turn die holding

screw slot in a vertical position. See Figure 4,

5. Insert male die into head of tool with the color

coded groove facing operator.

Do not attempt to insert dies into the tool while

holding the dies together. Dies are inserted into the

tool separately.

6. Insert female die into head of tool. Both color

Figure 4

7. Turn male die holding screw slot 1/4 turn to left

or right. (horizontal position) See Figure 5.

8. Release take-up lever, then push female die

down so that hole in female die lines up with hole

NOTE

i

3 of 8

408-1662

Rev A