| 数据搜索系统,热门电子元器件搜索 |
|
LM6364M 数据表(PDF) 8 Page - National Semiconductor (TI) |
|
|
|
|||||||||||||||||||||||||||||
LM6364M 数据表(HTML) 8 Page - National Semiconductor (TI) |
|
8 / 12 page ![]() Simplified Schematic Applications Tips The LM6364 has been compensated for gains of 5 or greater (over specified ranges of temperature, power supply voltage, and load). Since this compensation involved adding emitter-degeneration resistors in the op amp’s input stage, the open-loop gain was reduced as the stability increased. Gain error due to reduced A VOL is most apparent at high gains; thus, the uncompensated LM6365 is appropriate for gains of 25 or more. If unity-gain operation is desired, the LM6361 should be used. The LM6361, LM6364, and LM6365 have the same high slew rate (typically 300 V/µs), regardless of their compensation. The LM6364 is unusually tolerant of capacitive loads. Most op amps tend to oscillate when their load capacitance is greater than about 200 pF (in low-gain circuits). However, load capacitance on the LM6364 effectively increases its compensation capacitance, thus slowing the op amp’s re- sponse and reducing its bandwidth. The compensation is not ideal, though, and ringing or oscillation may occur in low-gain circuits with large capacitive loads. To overcompen- sate the LM6364 for operation at gains less than 5, a series resistor-capacitor network should be added between the in- put pins (as shown in the Typical Applications, Noise Gain Compensation) so that the high-frequency noise gain rises to at least 5. Power supply bypassing will improve the stability and tran- sient response of the LM6364, and is recommended for ev- ery design. 0.01 µF to 0.1 µF ceramic capacitors should be used (from each supply “rail” to ground); if the device is far away from its power supply source, an additional 2.2 µF to 10 µF (tantalum) may be required for extra noise reduction. Keep all leads short to reduce stray capacitance and lead in- ductance, and make sure ground paths are low-impedance, especially where heavier currents will be flowing. Stray ca- pacitance in the circuit layout can cause signal coupling be- tween adjacent nodes, so that circuit gain unintentionally varies with frequency. Breadboarded circuits will work best if they are built using generic PC boards with a good ground plane. If the op amps are used with sockets, as opposed to being soldered into the circuit, the additional input capacitance may degrade circuit performance. DS009153-3 www.national.com 8 |
|
|
链接网址 |
| ALLDATASHEET是否为您带来帮助? [ DONATE ] |
关于 Alldatasheet | 广告服务 | 联系我们 | 隐私政策 | 数据表链接 | 链接交换 | 制造商名单 All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |