Application Information

The table below, depicts the maximum operating supply volt-

age for each package type:

TABLE 1. Maximum Supply Voltage Values

SOT23-5

SO-8

Single Supply

10V

30V

Dual Supplies

Stable unity gain operation is possible with supply voltage of

5V for all capacitive loads. This allows the possibility of using

the device in portable applications with low supply voltages

with minimum components around it.

tional resistor and capacitor (shown below) should be placed

in the feedback path to achieve stability at unity gain over the

full temperature range.

The package power dissipation should be taken into account

when operating at high ambient temperatures and/or high

power dissipative conditions. Refer to the power derating

curves in the data sheet for each type of package.

In determining maximum operable temperature of the de-

vice, make sure the total power dissipation of the device is

considered; this includes the power dissipated in the device

with a load connected to the output as well as the nominal

dissipation of the op amp.

The device is capable of tolerating momentary short circits

from its output to ground but prolonged operation in this

mode will damage the device, if the maximum allowed junc-

tion temperation is exceeded.

APPLICATION CIRCUITS

Current Boost Circuit

The circuit in

Figure 2 can be used to achieve good linearity

along with high output current capability.

By proper choice of R

supply a minimal amount of current, thereby improving its

output linearity.

R

R

The circuit above has been set for a load of 100

Ω.

pected up to 120 mA

response across the load).

Undistorted Output Swing

vs Frequency

DS012348-86

Total Power Dissipation

vs Ambient Temperature

DS012348-65

DS012348-87

FIGURE 1. Typical Circuit for A

Operation (V

DS012348-92

FIGURE 2. Simple Circuit to Improve Linearity

and Output Drive Current

www.national.com

14