CS5.241, CS5.241-C1, CS5.241-S1

C-Line

This device is designed for installation in an enclosure and is intended for the general professional use such as in

industrial control, office, communication, and instrumentation equipment.

Do not use this power supply in equipment, where malfunction may cause severe personal injury or threaten human

life.

This device is designed for use in hazardous, non-hazardous, ordinary or unclassified locations.

The power supply does not fulfil the harmonic current standard EN61000-3-2. Do not use this power supply when the

following criteria apply:

a) the end-device is used within the European Union and

b) the end-device is connected to a public mains supply with a nominal voltage greater or equal 220Vac and

c) the power supply is:

- fitted in an end-device with an average input power greater than 75W or

- fitted in an end-device with a continuous input power greater than 75W or

- part of a lighting system.

Exception:

End-devices for professional applications with an input power > 1000W do not need to fulfill EN 61000-3-2.

Comments:

- The average input power must be determined in accordance with EN 61000-3-2.

- Industrial mains supplies with their own transformer are considered to be “non-public”.

- Where individual self-contained items of equipment are installed in a rack or case

(e.g. devices connected in parallel), they are regarded as being individually connected to the

mains supply. The rack or case need not be tested as a whole. Alternatively it is also permitted

to assess the whole rack or case. This is recommended for devices used in professional

applications with an input power greater than 1000W.

If PFC according to the Harmonics Standard EN 61000-3-2 is required, please use the QS5.241.

Jul. 2015 / Rev. 2.0 DS-CS5.241-EN

All parameters are specified at 24V, 5A, 230Vac, 50Hz, 25°C ambient and after a 5 minutes run-in time unless otherwise noted.

www.pulspower.com Phone +49 89 9278 0

Germany

3/25