ML50.100, ML50.109

MiniLine

Mar. 2007 / Rev. 1.0 DS-ML50.100-EN

All parameters are specified at 24V, 2.1A, 230Vac, 25°C ambient and after a 5 minutes run-in time unless otherwise noted.

www.pulspower.com Phone +49 89 9278 0

Germany

9/20

Fig. 14-1 Front side

DC-OK LED (green)

On when the voltage at the

output terminals is > 20 V

DC-OK LED and DC-OK signal

functions are synchronized

Output Voltage

Potentiometer

Turn to set the output voltage.

Factory set: 24.5V

Input Terminals

Spring-clamp terminals

N … Neutral input

L … Line (hot) input

... PE (Protective Earth) input

Output & Signal Terminals

Spring-clamp terminals

Dual terminals per pole

+

Positive output

-

Negative (return) output

Dual pins per pole

DC-OK Open collector output

Indicates an output

voltage higher than

20Vdc

All terminals are easy to access when mounted on the panel. Input and output terminals are separated from each

other (input below, output above) to help in error-free wiring. Mounting and wiring do not require any screwdriver.

Type

Quick-connect spring-clamp terminals

Solid wire

0.3-4mm

2

Stranded wire

0.3-2.5mm

2

American wire gauge

26-12 AWG

Ferrules

Allowed, but not required

Wire stripping length

6mm / 0.25inch

Pull-out force

12AWG:60N, 14AWG:50N, 16AWG:40N

(according to UL486E)

Fig. 15-1 Connecting a wire

Instructions:

a)

Use appropriate copper cables

b)

Follow local and national installation codes and

regulations!

c)

Ensure that all strands of a stranded wire enter

the terminal connection!

d)

Do not use the unit without PE connection.