RM024 – RAMP Wireless Module

Datasheet

Embedded Wireless Solutions Support Center:

http://ews-support.lairdtech.com

www.lairdtech.com/ramp

20

© Copyright 2015 Laird. All Rights Reserved

Americas: +1-800-492-2320

Europe: +44-1628-858-940

Hong Kong: +852 2923 0610

Note:

Contains FCC ID: KQL-RM024

IC: 2268C-RM024

The enclosed device complies with Part 15 of the FCC Rules and Industry Canada License Exempt

RSS Standard(s). Operation is subject to the following two conditions: (1) This device may not cause

harmful interference, and (2) This device must accept any interference received, including

interference that may cause undesired operation

Label and text information should be in a size of type large enough to be readily legible, consistent with the

dimensions of the equipment and the label. However, the type size for the text is not required to be larger than

eight pt.

verify compliance with FCC Part 15 Subpart B limits for unintentional radiators.

When integrated into the OEM’s product, these fixed antennas require professional installation preventing end-

users from replacing them with non-approved antennas. Any antenna not listed in the above table must be

evaluated for compliance with FCC Part 15.203 for unique antenna connectors. Contact Laird Technology for

assistance.

distances greater than 20 cm from the human body. Operation at distances of less than 20 cm requires

additional RF exposure evaluation and possible testing, including SAR requirement according to FCC RF Exposure

guideline.

authority to operate the equipment.

NOTE:

This equipment has been tested and found to comply with the limits for a Class B digital device,

pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection

against harmful interference in a residential installation. This equipment generates, uses, and can

radiate radio frequency energy and, if not installed and used in accordance with the instructions,

may cause harmful interference to radio communications. However, there is no guarantee that

interference will not occur in a particular installation. If this equipment does not cause harmful

interference to radio or television reception, which can be determined by turning the equipment off

and on, the user is encouraged to correct the interference by one or more of the following

measures:

 Re-orient or relocate the receiving antenna.

 Increase the separation between the equipment and the receiver.

 Connect the equipment to an outlet on a circuit that is different from that to which the receiver

is connected.

 Consult the dealer or an experienced radio/TV technician for help.

CAUTION:

“THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES AND INDUSTRY CANADA LICENSE-EXEMPT RSS

STANDARD(S). OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS: (1) THIS DEVICE MAY NOT CAUSE

HARMFUL INTERFERENCE, AND (2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED, INCLUDING

INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION.”