Issue: 1609 DRAFT RalfYe

In the effort to improve our products, we reserve the right to make changes judged to be necessary.

CONFIDENTIAL AND PROPRIETARY INFORMATION

This document contains confidential and proprietary information of Pulse Electronics, Inc. (Pulse) and is protected by copyright, trade secret and other state and federal laws.

Its receipt or possession does not convey any rights to reproduce, disclose its contents, or to manufacture, use or sell anything it may describe. Reproduction, disclosure or

use without specific written authorization of Pulse is strictly forbidden.

PART NUMBER: : DASCLINSERT

Series: Accessory

5

PACKAGING

Individually bagged; 48 per carton but sold individually.

ASSEMBLY

INSTALLATION INSTRUCTION

Step 1,

Drill or cut a hole 3~3.1 inches (76.2~78.74 mm) in drywall with two 0.5 inch diameter

tab cutouts 180° opposed. See Figure 1 and Figure 2.

Drywall thickness range: 3/8 ~1 inch

Step 2,

Check the two clamps can freely swing in and out by adjusting the screw’s position.

See Figure 3. Note: The clamps are limited in how far they can swing due to the

side wall of the sleeve. (Shown as Figure 3)

Screw Driver type: 2# PHILIPS DRIVE

Torque < 3 lb·ft ( 4 Nm)