Typical Characteristics

RELI-DA01/R

Series

LIGHTLINE

AC/DC-Converter

Variable

Default Value

Reset Value

Range of Validity

Actual Dim Level

254

254

0, Min Level - Max Level

Power on Level

254

254

0 - 255 (Mask)

System Failure Level

254

254

0 - 255 (Mask)

Min Level

Physical Min Level

Physical Min Level

Physical Min Level - Max Level

Max Level

254

254

Min Level - 254

Fade Rate

7 (45 steps/s)

7 (45 steps/s)

1-15

Fade Time

0 (no fade)

0 (no fade)

0-15

Short Address

255 (Mask)

no change

0-63

255 (Mask)

Search Address

FF FF FF

FF FF FF

00 00 00 - FF FF FF

Random Address

FF FF FF

FF FF FF

00 00 00 - FF FF FF

Group 0-7

0000 0000 (no group)

0000 0000 (no group)

0 - 255

Group 8-15

0000 0000 (no group)

0000 0000 (no group)

0 - 255

Group 0-15

255 (Mask)

255 (Mask)

0 - 255 (Mask)

Status Information

1xx0 xxxx

0x10 0xxx

0 - 255

Version Number

1

no change

Factory-defined

x = actual value depend on the operation status

DALI Declaration for Factory Variables (for Part 102)

DALI Declaration for Factory Variables (for Part 206)

Variable

Default Value

Reset Value

Received Command

Range of Validity

Dimming Curve

0

No change

0

0-1; (2 - 255 reserved)

Converter Features

0011 a101

No change

0011 a101

53; 61

Failure Status

0000 0000

No change

0000 0000

0 - 255

Converter Status

0000 0000

No change

0000 0000

0 - 255

Extended Version Number

1

No change

1

Factory-defined

Device Type

5

No change

5

Factory-defined

Physical min Level

1

No change

1

1-253

a = 0 Relay Function dissabled; a = 1 Relay Function enabled

DALI Command Set

Command Number

Command Name

Function

-

DIRECT ARC POWER

set directly the light level

0

OFF

switch off the light

1

UP

dim up the light

2

DOWN

dim down the light

5

RECALL MAX

recall the maximum light level

6

RECALL MIN

recall the minimum light level

The RELI-DA01/R has been accepted by agDALI as conforming to the DALI standard for Control Gear (IEC 62386-102)

and Device Type 5 (IEC 62386-206). It supports all relevant commands of the defined command set.

Not supported commands include the “QUERY LAMP FAILURE” and the “QUERY LAMP POWER ON”.

Additionally the features to disable the Relay Switch, set the output to PWM, change the PWM from active-

high to active-low are additional and not tested by DALI (refer to the RELI-DA01/R instruction manual).

www.recom-power.com

L-73

REV: 0/2015