PI3C3306LE datasheet(2/6 Pages) PERICOM

2 / 6 page

PS8417E

09/07/04

PI3C3305/PI3C3306

2.5V/3.3V, High Bandwidth, Hot Insertion,

2-Bit, 2-Port Bus Switch with Individual Enables

Maximum Ratings

(Above which the useful life may be impaired. For user guidelines, not tested.)

Note:

Stresses greater than those listed under MAXIMUM RAT-

INGS may cause permanent damage to the device. This is

a stress rating only and functional operation of the device

at these or any other conditions above those indicated in

the operational sections of this specification is not implied.

Exposure to absolute maximum rating conditions for ex-

tended periods may affect reliability.

Storage Temperature ............................................................–65°C to +150°C

Ambient Temperature with Power Applied ...........................–40°C to +85°C

Supply Voltage to Ground Potential .......................................–0.5V to +4.6V

DC Input Voltage ....................................................................–0.5V to +5.5V

DC Output Current............................................................................... 120mA

Power Dissipation ................................................................................... 0.5W

Capacitance (TA = 25°C, f = 1 MHz)

Parameters(5)

Description

Test Conditions

Typ.

Units

CIN

Input Capacitance

VIN = 0V

3.5

COFF

A/B Capacitance, Switch Off

5.0

CON

A/B Capacitance, Switch On

10.0

DC Electrical Characteristics (Over Operating Range, TA = –40°C to +85°C, VCC = 3.3V ±10%)

Parameters

Description

Test Conditions(1)

Min.

Typ.(2) Max.

Units

VIH

Input HIGH Voltage

Guaranteed Logic HIGH Level

2.0

VIL

Input LOW Voltage

Guaranteed Logic LOW Level

–0.5

0.8

IIH

Input HIGH Current

VCC = Max., VIN = VCC

±1

µA

IIL

Input LOW Current

VCC = Max., VIN = GND

±1

IOZH

High Impedance Output

Current

0 ≤ A, B ≤ VCC

±1

VIK

Clamp Diode Voltage

VCC = Min., IIN = –18mA

–0.73

–1.2

RON

Switch On Resistance(4)

VCC = Min., VIN = 0.0V, ION = 48mA or 60mA

Ω

VCC = Min., VIN = 2.4V, ION = 15mA

Notes:

1. For Max. or Min. conditions, use appropriate value specified under Electrical Characteristics for the applicable device type.

2. Typical values are at VCC = 3.3V, TA = 25°C ambient and maximum loading.

3. Not more than one output should be shorted at one time. Duration of the test should not exceed one second.

4. Measured by the voltage drop between A and B pin at indicated current through the switch. On-Resistance is determined by the lower of the

voltages on the two (A,B) pins.

5. This parameter is determined by device characterization but is not production tested.

PI3C3306LE 数据表(PDF) 2 Page - Pericom Semiconductor Corporation

PI3C3306LE 数据表(HTML) 2 Page - Pericom Semiconductor Corporation

Html Pages

1 2 3 4 5 6

数据表下载