Q106-R00xx datasheet(4/7 Pages) AVAGO

4 / 7 page

Optical Characteristics at TA = 25°C

Luminous Intensity

Total Flux

Peak

Color, Dominant

Viewing Angle

Luminous

Part Number

IV (mcd)

V (mlm)

Wavelength

½

Efficacy

(Low Current)

@ 0.5 mA[1]

@ 0.5 mA[2]

peak(nm)

d[3] (nm)

Degrees[4]

v[5]

HLMP-

Min.

Typ.

(lm/w)

Q156-H00xx

2.5

10.5

654

644

Q152-G00xx

1.6

654

644

P156-EG0xx

0.63

10.5

654

644

Notes:

1. The luminous intensity, Iv, is measured at the mechanical axis of the lamp package. The actual peak of the spatial radiation pattern may not be

aligned with this axis.

v is the total luminous flux output as measured with an integrating sphere.

3. The dominant wavelength,

d, is derived from the CIE Chromaticity Diagram and represents the color of the device.

1/2 is the off-axis angle where the liminous intensity is 1/2 the peak intensity.

5. Radiant intensity, Iv, in watts/steradian, may be calculated from the equation Iv = Iv/

v, where Iv is the luminous intensity in candelas and v is the

luminous efficacy in lumens/watt.

Optical Characteristics at TA = 25°C

Luminous Intensity

Total Flux

Peak

Color, Dominant

Viewing Angle

Luminous

IV (mcd)

V (mlm)

Wavelength

½

Efficacy

Part Number

@ 20 mA[1]

@ 20 mA[2]

peak(nm)

d[3] (nm)

Degrees[4]

v[5]

HLMP-

Min.

Typ.

(lm/w)

Q106-R00xx

100

400

280

654

644

Q102-N00xx

100

654

644

P106-Q00xx

130

280

654

644

Absolute Maximum Ratings at TA = 25°C

Parameters

Title

DC Forward Current [1]

50 mA

Peak Forward Current [2]

300 mA

Average Forward Current [2,3]

30 mA

Transient Forward Current (10

s Pulse) [4]

500 mA

Power Dissipation

100 mW

Reverse Voltage

5 V

Junction Temperature

110°C

Operating Temperature

-55°C to +100°C

Storage Temperature

-55°C to +100°C

Lead Soldering Temperature

260°C for 5 seconds

[1.6 mm (0.063 in.) from body]

Reflow Soldering Temperature

260°C for 20 seconds

Notes:

1. Derate linearly as shown in Figure 6.

2. Refer to Figure 7 to establish pulsed operating conditions.

3. Maximum IAVG at f = 1 kHz, DF = 10%.

4. The transient peak current is the maximum non-recurring peak current the device can withstand

without damaging the LED die and wire bonds. It is not recommended that the device be

operated at peak currents above the Absolute Maximum Peak Forward Current.

Q106-R00xx 数据表(PDF) 4 Page - AVAGO TECHNOLOGIES LIMITED

Q106-R00xx 数据表(HTML) 4 Page - AVAGO TECHNOLOGIES LIMITED

Html Pages

1 2 3 4 5 6 7

数据表下载