PR02-FS

www.vishay.com

Vishay BCcomponents

Revision: 15-Feb-17

5

Document Number: 28915

THIS DOCUMENT IS SUBJECT TO CHANGE WITHOUT NOTICE. THE PRODUCTS DESCRIBED HEREIN AND THIS DOCUMENT

Pulse performance after a rectangular pulse of defined duration is applied

TESTS PROCEDURES AND REQUIREMENTS

All tests are carried out in accordance with the following

specifications:

• IEC 60115-1, generic specification (includes tests)

The test and requirements table contains only the most

important tests. For the full test schedule refer to the

documents listed above.

The tests are carried out in accordance with IEC 60068-2-xx

test method and under standard atmospheric conditions in

accordance with IEC 60068-1, 5.3.

Climatic category LCT / UCT / 56 (rated temperature range:

lower category temperature, upper category temperature;

damp heat, steady state, test duration: 56 days) is valid.

Unless otherwise specified the following values apply:

• Temperature: 15 °C to 35 °C

• Relative humidity: 25 % to 75 %

• Air pressure: 86 kPa to 106 kPa (860 mbar to 1060 mbar)

For performing some of the tests, the components are

mounted on a test board in accordance with IEC 60115-1,

4.31.

In test procedures and requirements table, only the tests

and requirements are listed with reference to the relevant

clauses of IEC 60115-1 and IEC 60068-2-xx test methods.

A short description of the test procedure is also given.

Pulse Duration (s)

1

10 000

10

100

1000

TEST PROCEDURES AND REQUIREMENTS

IEC

60115-1

CLAUSE

IEC

60068-2-

TEST

METHOD

TEST

PROCEDURE

REQUIREMENTS PERMISSIBLE

CHANGE

(

R

4.4.1

-

Visual examination

No holes; clean surface; no damage

4.4.2

-

Dimensions (outline)

Gauge (mm)

See Dimensions table

4.5

-

Resistance

± 10 % R

± 20 % R

4.6.1.1

-

Insulation resistance

500 V after 1 min;

metal block method

4.7

-

Voltage proof

No breakdown or flashover

4.8

-

Temperature

coefficient

At (20 / -55 / 20) °C

and (20 / 155 / 20) °C

 ± 250 ppm/K

4.16

21 (Ub)

21 (Uc)

Robustness of

terminations

Tensile, bending, and torsion

No damage

R