UM1871 datasheet(7/64 Pages) STMICROELECTRONICS

7 / 64 page

DocID027604 Rev 3

7/64

UM1871

Overview

1.2

Demonstration software

Demonstration software is preloaded in the Flash memory of the board for easy

demonstration of the device peripherals in stand-alone mode. For more information and to

download the latest version available, refer to the STM32446E-EVAL demonstration

software at www.st.com.

1.3

Order code

To order the evaluation board based on STM32F446ZE MCU, use the order code

STM32446E-EVAL.

1.4

Delivery recommendations

Before using the board for the first time, verify that nothing was damaged during shipment

and that no components are unplugged or lost. When the board is extracted from its plastic

bag, it must be checked that no component remains in the bag.

The main components to verify are:

The microSD card which may have been ejected from the CN4 connector (top left

corner of the board).

The dual-interface EEPROM board (ANT7-M24LR-A) which may have been unplugged

from the CN1 connector (top left corner of the board).

Note:1

The plastic protection on the camera should be removed carefully as the connection is very

fragile.

Note:2

For all information concerning the version of the MCU used on the board, its specification

and possible related limitations, visit the ST web site (www.st.com) to download relevant

datasheet and errata sheet.

Warning:

Warning: There is an explosion risk if the battery is replaced

by an incorrect one. Make sure to dispose of used batteries

according to the instructions.

UM1871 数据表(PDF) 7 Page - STMicroelectronics

UM1871 数据表(HTML) 7 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64

数据表下载