ST72325AR7-Auto datasheet(39/243 Pages) STMICROELECTRONICS

39 / 243 page

Obsolete

Product(s)

- Obsolete

Product(s)

ST72325xxx-Auto

Central processing unit (CPU)

Doc ID 13770 Rev 3

39/243

5.3.1

Accumulator (A)

The accumulator is an 8-bit general purpose register used to hold operands and the results

of the arithmetic and logic calculations as well as data manipulations.

5.3.2

Index registers (X and Y)

These 8-bit registers are used to create effective addresses or as temporary storage areas

for data manipulation (the Cross-Assembler generates a precede instruction (PRE) to

indicate that the following instruction refers to the Y register.)

The Y register is not affected by the interrupt automatic procedures.

5.3.3

Program counter (PC)

The program counter is a 16-bit register containing the address of the next instruction to be

executed by the CPU. It is made of two 8-bit registers PCL (Program Counter Low which is

the LSB) and PCH (Program Counter High which is the MSB).

5.3.4

Condition code (CC) register

The 8-bit condition code register contains the interrupt masks and four flags representative

of the result of the instruction just executed. This register can also be handled by the PUSH

and POP instructions.

These bits can be individually tested and/or controlled by specific instructions.

Reset value:

111x1xxx

543

Table 8.

Arithmetic management bits

Bit Name

Function

Half carry

This bit is set by hardware when a carry occurs between bits 3 and 4 of the ALU

during an ADD or ADC instructions. It is reset by hardware during the same

instructions.

0: No half carry has occurred.

1: A half carry has occurred.

This bit is tested using the JRH or JRNH instruction. The H bit is useful in BCD

arithmetic subroutines.

Negative

This bit is set and cleared by hardware. It is representative of the result sign of the

last arithmetic, logical or data manipulation. It is a copy of the result 7th bit.

0: The result of the last operation is positive or null.

1: The result of the last operation is negative (that is, the most significant bit is a logic

1).

This bit is accessed by the JRMI and JRPL instructions.

ST72325AR7-Auto 数据表(PDF) 39 Page - STMicroelectronics

ST72325AR7-Auto 数据表(HTML) 39 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

数据表下载