USBUF01P6

4/7

®

EMI FILTERING

Current FCC regulations requires that class B computing devices meet specified maximum levels for both

radiated and conducted EMI.

- Radiated EMI covers the frequency range from 30MHz to 1GHz.

- Conducted EMI covers the 450kHz to 30MHz range.

For the types of devices utilizing the USB, the most difficult test to pass is usually the radiated EMI test.

For this reason the USBUF01P6 device is aiming to minimize radiated EMI.

The differential signal (D+ and D-) of the USB does not contribute significantly to radiated or conducted

EMI because the magnetic field of both conductors cancels each other.

The inside of the PC environment is very noisy and designers must minimize noise coupling from the

different sources. D+ and D- must not be routed near high speed lines (clocks spikes).

Induced common mode noise can be minimized by running pairs of USB signals parallel to each other and

running grounded guard trace on each side of the signal pair from the USB controller to the USBUF device.

If possible, locate the USBUF device physically near the USB connectors. Distance between the USB

controller and the USB connector must be minimized.

placed as close to the driver chip as is practicable.

The USBUF01P6 ensures a filtering protection against ElectroMagnetic and RadioFrequency

Interferences thanks to its low-pass filter structure. This filter is characterized by the following parameters:

- cut-off frequency

- Insertion loss

- high frequency rejection.

ESD PROTECTION

In addition to the requirements of termination and EMC compatibility, computing devices are required to

be tested for ESD susceptibility. This test is described in the IEC 61000-4-2 and is already in place in

Europe. This test requires that a device tolerates ESD events and remains operational without user

intervention.

The USBUF01P6 is particularly optimized to perform ESD protection. ESD protection is based on the use

of device which clamps at:

This protection function is splitted in 2 stages. As shown in figure A5, the ESD strikes are clamped by the

Such a configuration makes the output voltage very low at the output.

Fig. A3: USBUF01P6 typical attenuation curve.

Fig. A4: Measurement configuration.

f/Hz

1.0M

3.0M

10.0M

30.0M

100.0M

300.0M

1.0G

3.0G

-25.00

-22.50

-20.00

-17.50

-15.00

-12.50

-10.00

-7.50

-5.00

-2.50

0.00

dB

-

-

-

-

-

-

-

-

-

-

TEST BOARD

50

Ω

Vg

50

Ω

V

CL

V

BR

R

d

I

PP

⋅

+

=